Table of Contents
Advertisement
ON-SCREENOPERATION
%
G-COOE
MENWTV
CHANNELI
SP/LP
TRACKING
TYPE
(+, -)
CLEAR
o-9
0:
~.
OK
(New Zealand only)
Note on sky decoders and
recording
1.
2.
There are at present two types
of sky decoders available in
New Zealand.
Base Band Decoder (no
remote
controlsupplied, o ldertype).
YOU cannotsuccessfully record
G-Code programmed usingthis
typeof decoder.(Unlessyour
videois modifiedinternallyfirst.)
Contact S kyTVfor details.
IRD Oecoder
(suppliedwith Sky
Remote and with UHFoutput).
This decoder allows you to
programme recordings using the
G-Code function. You can use the
Sky CODENUMBERS to record
Sky TV programmed with your
VCR, However, please note the
following limitations.
(a) The Sky CODENUMBERS used
with the VCR can not change the
channels on the Sky Decoder.
This means you must first
preselect the Sky channel you
want to record (movies, sport,
news)
(b) The VCR will then turn on and
record the programme position
which has been set for Sky. (e.g.
programme position "4").
The Sky channel you record
(movies, sport, news) will depend
on which channel the decoder was
left on.
(c) Remember the first time You use a
Sky CODENUMBER, the
programme position number
('(PR") on
the video
needs to be
set the same
for all threeSky
channels.
Thiswill depend onthe programme
positionnumberyouallocated for
Sw in theset
up. ie programme
position number "4'.
G-CODE TIMER RECORDING
PROGRAMMING
Programming
on the VCR display
You can programme
or confirm a G-CODE
timer recording
on the VCR display even if the
TV
is
turned off.
1
2
Press the G-CODE button.
UsincJ
the numeric
buttons,
enter the
Cod; number for the programme you
want to record. (e.g. 489135)
If you entered a wrong number, press the
CLEAR
button to delete
it, then enter the
correct number.
3
Press the OK button.
Note:
If the programme
position number (PR) displays
"--",
please refer to page 14.
Additional
settings
Daily/Weekly
recording
Press the MENU/TV button repeatedly
to
select:
for daily recording (Monday
,through Friday)
for weekly recording (the
same programme
every
week)
Changing the off time
Each press of the CHANNEL/lRACKiNG
(+
or –) button will change the recording off time
by units of 10 minutes.
Recording tape speed setting
Press the SP/LP button repeatedly
to display
the desired tape speed.
No display:
Standard
Play mode
LP:
Long Play mode
Setting
the recording
type
Press the TYPE
button repeatedly
until the
desired
type is displayed.
F: Film
s:
sports
d: Drama
M: Music
n: News
A:
Animation, cartoon
E: Educational programme
a
When allthesettincrs
areas desired,
press the OK butte;.
You can programme another recording by
repeating steps 2 to 4.
Insert a video cassette with
erasure-prevention
tab.
Make sure the tape is longer than the total
recording time.
Press the G-CODE button.
The timer indicator (n) will light on the
VCR display and the VCR goes into
timer recording stand-by mode.
15
Advertisement
Table of Contents
