Single Wiring - AAD 7001 Owner's Manual

7001
YOUR HEAD SHOULD BE AT SAME HEIGHT AS
CENTER OF SPEAKERS
Speakers and electronics terminals have corresponding (+) and (-) terminals. It is important
to connect both speakers identically: (+) on the speaker to (+) on the amplifier and (-) on the
speaker to (-) on the amplifier. The hole in the center of each speaker terminal is intended
for use with banana-type connectors. We recommend that you use this type of connection to
avoid any potential of connections being shorted out on the back panel.
For maximum transfer of energy from amplifier to the speaker, you should use as short a run
of speaker cable as possible. Try to use the best quality cable available. It is difficult to say
what brand or model cable offers the best performance since the overall result is also
dependent on source of electronic you are using along with your particular room set up.
High Frequency
-
+
-
+
Low Frequency
-
+
Amplifier
7001
The 7001 speaker stand offers the best
performance with the speaker. The optimum
height of a listener's head should be the same
as the speaker baffle center.
WIRING UP YOUR SPEAKERS
For single-wire connection, leave the shorting bars in place
and connect only a single set of speaker wires (two
conductors). The positive conductor connects to the upper
positive terminal and the negative conductor to the lower
negative terminal.

SINGLE WIRING