Advertisement
Amplifier Power
We recommend that you use an amplifier with power rating at least a 100watt RMS or
ideally 300watts plus per channel. These 7001s have a vast dynamic range and using a large
power amplifier to power them will allow them to reach their full potential.
Amplifiers with up to 1000 watts RMS output can produce lifelike dynamics on transients
without stress or strain.
Headroom is not audible but a lack of it certainly is.
Each time you run your system you may need about 15minutes of initial playing before the
sound starts to take on a dimension of breathtaking clarity.
The 7001s will even reveal how your amplifier sounds whether it is just turned on cold or
been running warm for a while.
Speakers Cables, Interconnects & Power Cords
Due to their revealing nature, the 7001 speakers will discriminate between speaker cables
and interconnects with ease. It will bring a new palette of colors to what you have ever heard
before to your recordings. So even changing between cables will bring changes to you
sound. You should experiment to what is sounding to your idea of transparency.
Program Material
The 7001 is neutral when it comes to producing sound. It is not slanted to any side of the
audio spectrum. It will therefore reveal more about the recordings and the process of how
they were recorded more than the producer and artist who created them know.
System Type: 2 way loudspeaker 5 inch cone woofer, horn loaded ribbon tweeter.
Bass Loading: 6.5 inch critically tuned passive radiator.
Crossover: 12dB/Octave at 3 KHz
Low-Frequency Transducer: Cast magnesium alloy frame, High Flux Neodymium-Iron-
High Frequency Transducer: Neodymium magnet system. Horn loaded Aluminum ribbon
Cabinet: 1.5 inch thick MDF side panels with lead damping.0.5 inch Aluminum front and
back panels
Frequency Response: 25Hz-50KHz +/- 3dB (dependant upon room acoustics).
Impedance: 8 Ohms Nominal.
Recommended Amplifier Power: 100 watts minimum 1000 watts maximum.
SPECIFICATIONS
Boron magnet system, High Excursion 2-inch Copper Clad
aluminum voice coil. Aluminum cone, Butyl-Rubber
surround.
1-7
Advertisement
