Table of Contents
Advertisement
Quick Links
Mechanical Outline
3/5/99
2035.ai
JK
User's Manual
4x Ø.125
0.125"
2.50"
1.50"
2x Ø.125
2035
3.70"
2035 O
3.75"
4.00"
Step Motor Drivers
0.25"
0.25"
0.15"
3.00"
.875"
Copyright 1999
Applied Motion Products, Inc.
404 Westridge Drive Watsonville, CA 95076
Tel (831) 761-6555
(800) 525-1609
Fax (831) 761-6544
motors • drives • controls
Advertisement
Table of Contents
Related Manuals for Applied Motion Products 2035
Summary of Contents for Applied Motion Products 2035
- Page 1 2x Ø.125 2035 3.70" 2035 O 3.75" 4.00" Step Motor Drivers 0.25" 0.25" 0.15" 3.00" .875" Copyright 1999 Applied Motion Products, Inc. 404 Westridge Drive Watsonville, CA 95076 Tel (831) 761-6555 (800) 525-1609 Fax (831) 761-6544 motors • drives • controls...
- Page 2 Motor steps when STEP input turns off. 10 µsec minimum low pulse. 50 µsec minimum set up time for This manual is for 2035 and 2035 O drives of revision level E. Earlier drives had direction signal. Step input is run/stop in oscillator mode. (0 =run, fewer features and different connections that revision E, so they require a different 1 = stop.)
- Page 3 • Automatic 50% idle current reduction (switch selected) #4 screws • Built in ramping pulse generator with adjustable speed, accel, decel (2035 O) • 0 - 5000 Hz oscillator speed range (2035 O) • Optically isolated Tach output for monitoring speed (2035 O)
- Page 4 The maximum supply current you will need is the sum of the two phase points. Please examine it now. currents. However, you will generally need a lot less than that, depending on the motor type, voltage speed and load conditions. That's because the 2035 and 2035 jumper for selecting power...
- Page 5 If you need information about choosing a power supply, please read Choosing a Power Supply on page 13 of this manual. The 2035 O was designed to be used with active logic and for that reason has optically isolated inputs. To activate the optoisolators a small, but not insignificant If you're power supply does not have a fuse on the output or some kind of short amount of current at 5 to 24 volts DC is required.
- Page 6 Using a Remote Speed Control Potentiometer Grn/Wht Grn/Wht The 2035 O step motor driver includes an analog signal input connector that can be White White lead lead used to control the oscillator speed externally. Normally, an on board potentiometer motor motor controls the speed.
- Page 7 Drives with an O suffix are equipped with internal pulse generators that you can use to drive the motor. The 2035 and 2035 O drives contain optical isolation circuitry to prevent the To set the drive to oscillator mode, simply find the electrical noise inherent in switching amplifiers from interfering with your circuits.
- Page 8 BASE = 125mA 125mA The 2035 drive current is easy to set. If you wish, you can learn a simple formula AMPS/PHASE AMPS/PHASE for setting current and never need the manual again. Or you can skip to the table on...
Need help?
Do you have a question about the 2035 and is the answer not in the manual?
Questions and answers