Advertisement
P61-KBD
It is better to place the MIDI-IN connector on the rear panel of the instrument for easier operation. It is
necessary to drill three holes in the instrument panel however. The MIDI-IN connector can be installed near
the jack connectors (see pic. 2.2-2). In that case, MIDI-IN connector installation procedure is as follows:
a) Flip the front cover over and return it to its original closed position on top of the synth.
b) Drill three holes (one with 16 mm diameter and two with 3,5 mm diameter) in the rear panel (see pic. 2.2-3).
Work carefully so as to not drill the parts inside the instrument (pic. 2.2-4).
c) Clean the edge of the holes with small rasp (pic. 2.2-5). Also clean the holes from the inside after the
instrument opening..
d) Clean all iron sawdust and raspings from the inside of the instruments
Clean all iron sawdust and raspings from the inside of the instruments, they can cause short circuits or serious
Clean all iron sawdust and raspings from the inside of the instruments
Clean all iron sawdust and raspings from the inside of the instruments
electrical damage if left in the instrument. Please clean the instrument carefully!
e) Get flat connector of bunched cables (part of the kit) through the hole in rear panel into the instrument (pic.
2.2-6).
f) Insert the DIN socket into hole in rear panel (pic. 2.2-7) and fix it to the panel using screws, washers and nuts
(pic. 2.2-8). All material is a part of the kit.
All rights reserved. No part of this publication may be reproduced in any form without the written permission of CHD Elektroservis.
MIDI Interface for Korg Poly-61 Keyboard
Pic. 2.2- - - - 1 1 1 1
Pic. 2.2
Pic. 2.2
Pic. 2.2
Pic. 2.2- - - - 3 3 3 3
Pic. 2.2
Pic. 2.2
Pic. 2.2
Copyright © 2018 CHD Elektroservis.
5
Model 8-435 ver. 1.0
Pic. 2.2- - - - 2 2 2 2
Pic. 2.2
Pic. 2.2
Pic. 2.2
Pic. 2.2- - - - 4 4 4 4
Pic. 2.2
Pic. 2.2
Pic. 2.2
Advertisement
