Ground Preparation; Installation Notes - Freeflow Spas Excursion Instructions Manual

It may be necessary to remove a gate, part of a fence, or other movable obstructions in order to roll the spa to its
installation site. About ten percent of the time, a crane is the only way to install the spa by lifting it to its final destination.
If the spa has to be taken off of the cart to go over a wall (either because the entry area is too narrow, the eaves are
too low, the corner is too tight, or the stairway is too steep), a crane will be required. Don't be alarmed!
The crane has a truck-mounted boom which can fit right in your driveway. It is run by a licensed and insured
operator. For a charge, the crane operator will lift your spa over walls, buildings, or any other obstruction and place it
as close to the installation site as possible. Crane delivery typically takes an average of 30 minutes to complete.
NOTE: If your spa delivery requires the use of a crane, you may be required to pay for its services at the completion
of the delivery.

GROUND PREPARATION

Your spa has been engineered to perform on all kinds of common yard surfaces. While a concrete slab is best
for long-term use*, other foundations are acceptable so long as a level base is prepared prior to delivery. Three
foundation base pictures, shown at right, represent examples of alternatives to a concrete slab for spas installed
without gazebos or other accessories.
*NOTE: A reinforced concrete pad at least four inches thick or a deck that is able to withstand more than 115 lbs. per
square foot is required.

INSTALLATION NOTES:

As a homeowner, it is your responsibility to provide a suitable, level
foundation for your spa. Keep in mind that most delivery crews are not
equipped to level and prepare spa sites.
If you are interested in having a concrete slab, brick surface, or wood
deck installed, your dealer should be able to suggest a qualified,
licensed contractor.
NOTE: In order for the spa to operate properly and the internal
plumbing to drain completely, you must ensure that the spa is leveled
(within ½" per 10') after it has been installed. Do not shim you spa in
any manner, as this could cause the cabinet to warp, thereby voiding
the warranty.
Pre-Delivery Instructions
x
Page 4
Page x
FOUNDATIONS FOR SPAS
WITH ACCESSORIES
CONCRETE PADS
BRICK SURFACES
WOOD DECKING
x