Technaxx TX-92 User Manual page 3

Charge the Power Bank fully before use (~ 7–9 hours)
Connect the Micro USB port of the charging
cable* (*included) to the Power Bank. Then connect
the USB port of the charging cable to the USB port
of a AC adapter** (**not included) or to a
PC/Notebook (see right picture).
During charging the RED LED is blinking.
The number of lighting of the RED LEDs is
depending on the amount of power in the power
bank.
When only one LED is lighting that means the
Power Bank is almost empty, 4 LED lighting means
the Power Bank is almost full of power.
Charging: Use a 5V/1A adapter** (**not included) to
charge the Power Bank. During charging the Blue
LED L1&L2 steady on, RED light blinking. When
fully charged the RED L1&L2&L3&L4 are steady on.
Charging time of the
Capacity
Power Bank
6000mAh approx. 7–9 hours
Functions of remote control
Long press A, L1&L2 will flash for 3 times and then
turn off, recording begins; press long B to save the
videos and to switch off – all LEDs are lighting shortly
and then go off.
On standby mode, press C, L1&L2 will flash for 3
times, and then turn off, recording begins; press C to
save the videos, L1&L2 turn on, the Power Bank goes
to standby mode.
IR light can be turned on/off manually only while
recording. While recording, press D, L3 will flash for 3
times, and then turn off – IR lights turn on; Press D
again, L4 will flash for 3 times, and then turn off. The
IR light turns off and is switched off.
Attention: When you have a problem with the remote
control, press K2 to reset.
iPhone 5 Sony Z1, Z2
2.5 times 1.2 time
Galaxy
Note3
1.2 times
A: Turn on / Video recording
B: Save videos / Turn off
C: Steady on/ Video recording
D: IR light on / off
Galaxy
S4, S5
1.4 time