Using The Input Button; Programming The Remote To Operate Other Components; Find Out If You Need To Program The Remote; Programming The Remote - RCA 27F530T User Manual

Using the Remote Control
REVERSE, PLAY, FORWARD, RECORD, STOP, PAUSE If programmed, provides
transport control for some remote-controllable VCRs or DVD players.
SEARCH In VCR mode, accesses Index Search feature.
SPEED In VCR mode, selects a recording speed.
VCR Puts the remote in VCR mode and, if auto tuning is enabled, will turn on the
TV and tune to the correct video input channel.
ZOOM In DVD mode, zooms in on the picture.

Using the INPUT Button

Use the INPUT button to scroll through the available video input channels and
view components you have connected to the TV.
1. Make sure the component you want to view is turned ON.
2. Press INPUT to tune to an available video input source and view the
component.
3. To return to the previous channel, continue pressing INPUT.
DVD
VCR
DVD and
VCR buttons
VOL
MUTE GO BACK
CLEAR
PRESETS
CC
GUIDE
1
4
7
INPUT
REVERSE PLAY
RECORD
REVERSE
AGAIN ZOOM
and PLAY
SPEED
SEARCH
buttons
You'll use these buttons when

programming the remote.

10
Graphics contained within this publication are for representation only.
ON OFF
ON•OFF
TV
button
CH
MENU
OK OK
SKIP
INFO
2 3
5 6
8 9
ANTENNA
0
FORWARD
STOP PAUSE
OPEN CLOSE
STOP
button
Programming the Remote to Operate Other
Components
The universal remote can be programmed to operate most
brands of remote controllable components. The remote is
already programmed to operate most RCA, GE, and Proscan
components.
Notes: The TV button can't be programmed on this remote.
The remote may not be compatible with all brands and models of
components. It also may not operate all functions of the remote that
came with your component.

Find Out If You Need to Program the Remote

To determine whether the universal remote needs to be
programmed for your component, turn the component ON.
For example, to program the remote for a VCR, turn on the
VCR. Point the remote at the VCR, and press the VCR button.
Then press ON•OFF or CH + (channel up) or CH – (channel
down) to see if the VCR responds to the remote commands. If
the component does not respond, the remote needs to be
programmed.
Programming the Remote
There are two ways to program the remote control:
• automatic code search
• direct entry
Chapter 2