Default Display - heat-timer DIGI-SPAN VSP Elite Installation And Operation Instructions Manual

9
Setting the Control to Factory Default
To Reset the VSP Elite control to its original factory defaults, power down the control. Hold down the
SET and DOWN buttons while powering the control back up until the Loading Default Values screen
appears. The Display will direct you to the Startup menu after the defaults are loaded to program the
control.
When resetting the control to original factory defaults all
control settings will be over written and will no longer exist.

Default Display

The default display will show the current Secondary Loop/System temperature and the Target
temperature. In addition, by clicking the Up or Down button, the display will show the current
Outdoor temperature and the current Return temperature, only if the return sensor is connected to T3±
terminals. However, if no return sensor is connected, the control will display the current Outdoor
temperature and the Outdoor Cutoff on a click on the up or down buttons.
ALERT
VSP Digi-Elite Installation & Operation Manual
SET
SET
SET
Loading Default
Values...
SET
SET
SET
SYSTEM= 148 F
TARGET= 150 F
SET
SET
SET
SET
Outdoor= 48 F
Return= 125 F
SET
Outdoor= 48 F
Cutoff= 65 F
SET