Table of Contents
Advertisement
3.
Place the main body on a flat, stable surface, and then place the assembled jar
and jar base on the top of the main body, insert it by aligning the three protruding
tabs on the jar base to the notch on the main body. Turn it slightly in clockwise
direction till it locks with the main body.
4.
Place the lid with measuring cap onto the jar.
NOTE: Make sure the plastic lid is always securely in place on top of the jar
before operating the product.
1.
Place the main body on a flat, stable surface.
2.
Fill the jar with the desired foods. Put the lid on top of the jar and press down.
Insert the measuring cap to the center of the lid, by align the marking to the
"Unlock" end of the arrow, and turn it in counterclockwise slightly, to lock tightly.
3.
Put the assembled glass jar and jar base on the main body, insert it by aligning
the three protruding tabs on the jar base to the notch on the main body, and then
turn it slightly in clockwise direction till it locks with the main body. The machine
was fully assembled now.
4.
Plug the unit into a standard 120-volt AC electrical outlet. The blue light on the
display become bright for 3 seconds and then go off. The blender is in "OFF"
mode now. The signal means the power is well connected and ready for working.
Otherwise, check the power connection to see if it is correct.
5.
Press "ON/OFF" button, the blue light bright, "
blender is in the "Stand-by" mode now. If there is no pressing any others
button to follow, the blue light will disappears after 3 seconds and the blender will
automatically shut off after 3 minutes, back to "Off" mode.
6.
After press the "ON/OFF" button, press the "PULSE", "ICE", "SMOOTHIE" button
to choose direct function, the default setting will appears and direct start the
blender working, the timer start to count down.
NOTE: when choosing the "PULSE", "ICE", "SMOOTHIE" function, the default
setting is "120 10", that means 120 seconds time and speed level 10. It is the
maximum time and speed of the blender, and it cannot be changed in these
functions, just can press "ON/OFF" button to stop it, or press the chosen function
again for back to "Stand-by" mode.
1> "PULSE" function:
HOW TO USE
www.Ginnys.com
4
on
" will appears on the display, the
Advertisement
Table of Contents
