Ⅱ . In Order To Connect The Controller Normally ，The Ip Address Must Be Set As Follows - Brother LT-5100 User Manual

LT-5100 PC Real-time Video Controller V7.6
1). Appear " DirectX", click on "Yes"
2). "DirectX"box pops up, select"display" and click on "Disable"
Then Figure 10 will be shown which means the option is already forbidden.
Ⅱ. In order to connect the controller normally，the IP address must be set as follows:
Please set IP to "192.168.18.38"， set Subnet Mask to "255.255.255.0"， definitely can not use
the IP address in Table 5.1 of《the IP address correspond to the DIP switch》.For not affecting
other functions of the computer network, you can use advanced configuration of TCP/IP bundling
several IPs. As shown in Figure 5-5, one network card bundling several IP addresses, of which,
Figure 9: Forbid DirectDraw speedup
Figure 10 the interface of after forbidding
Figure 8
Page 11 of 22