Remote Management - Lenovo ThinkSystem SN850 Product Manual

Table 27. Light path diagnostic panel LEDs
LED Meaning
LIGHT PATH The light path diagnostics panel is operational.
SYSTEM A system board error is detected.
BOARD
NMI A non-maskable interrupt (NMI) occurred.
CPU MISMATCH The processors are mismatched.
TEMP An over-temperature condition occurred that was critical enough to shut down the server.
MEMORY A memory fault occurred. The corresponding DIMM error LEDs on the system board are also
lit.
STORAGE BP 1 A hard disk drive backplane error has occurred.
M.2 A M.2 backplane error has occurred.
The front of the server also houses an information pull-out tab. See
tab shows the network information (MAC address and other data) to remotely access XClarity Controller.

Remote management

Lenovo XClarity Controller (XCC) is an all-new embedded management engine common in every
ThinkSystem server.
There are two ways to access the management processor:
Command-line interface. To access the CLI interface, use SSH to log in to the management
processor.
Web-based interface. To access the web-based interface, point your browser to the IP address for
the management processor. The new intuitive interface includes at-a-glance visualizations and
simple access to common system actions. The dashboard is shown in the following figure.
Figure 11. Lenovo XClarity Controller dashboard
Lenovo ThinkSystem SN850 Server
Figure 2 for the location. A label on the
33