National Instruments NI PXI-4060 Getting Started Manual page 12

Panel Mounting the USB DMM
To mount the USB DMM on a board or panel, complete the following steps while referring to Figure 8.
1 Top Screw Hole
Notes Do not apply the rubber feet to the USB DMM when panel mounting.
Apply strain relief, as described in the
1. Download and print the panel mounting template PDF attached in the KnowledgeBase document.
Go to
ni.com/info
2. Using the template, mark the bottom point and top point on the panel. The points will be 162 mm
(6.375 in.) apart.
3. Remove the USB cable from the connector on the USB DMM.
4. Screw a #8 or M4 screw into the bottom point on the panel.
5. Set the USB DMM on the screw by fitting it into the bottom screw notch on the underside of
the device.
6. Screw a #8 or M4 screw through the USB DMM top screw hole into the panel.
NI Digital Multimeters Getting Started Guide
1
Figure 8. Mounting the USB DMM on a Panel
USB Cable Strain Relief
and enter the info code
rd3233
12
2 Bottom Screw Notch
section, before panel mounting.
to locate the KnowledgeBase.
2
ni.com