Advertisement
I/O wiring
CL1XY2-DT1D5S
Flat cable
Isolation
Flat cable
dedicated
for I/O
to CC-Link/LT
DC DC
R
+24V
+24V
DA
R
Y0
DB
X0
Internal
24G
24G
circuit
R
4.2 Connection to sensor
• When using a two-wire type sensor
When using a three-wire type sensor
Connected to +24 V
Connected to +24 V
cable
cable
Bleeder resistor *1
X *
X *
Detection
Detection
circuit
circuit
24G
24G
Sensor (NPN)
Sensor (NPN)
Replace * in the figure with the used input No.
Notes:
*1 Bleeder resistor
When connecting a two-wire type sensor or input equipment having parallel
resistor, select a sensor or equipment whose leakage current is 1.7 mA or
less.
If the leakage current is more than 1.7 mA, connect a bleeder resistor
obtained in the following calculation formula.
Circuit image
Leakage
current
Unit
Sensor
Input impedance
Detection
5.6 kΩ
circuit
R
1.7 mA or less
R: Bleeder resistor
24V DC
×
R (kΩ) < 1.7 (mA) / Leakage current (mA) - 1.7 (mA)
5.6 (kΩ)
The power capacity W of the bleeder resistor R is as follows:
2
W = (Input voltage)
/R
• Make sure that both the ON and OFF time of the input signal are 1.5ms or
more.
5.
Specifications
5.1 General specifications
Item
Specification
Ambient
working
0 to 55°C (32 to 131°F)
temperature
Ambient storage
-25 to 75°C (-13 to 167°F)
temperature
Ambient
operating
5 to 95%RH: Dew condensation shall not be considered.
humidity
Ambient storage
5 to 95%RH: Dew condensation shall not be considered.
humidity
Item
Specification
When intermittent vibration is present
Frequency
Acceleration
−
10 to 57 Hz
Vibration
0.5A
2
57 to 150 Hz
9.8 m/s
resistance (*1)
When continuous vibration is present
L
Frequency
Acceleration
−
10 to 57 Hz
0.5A
2
57 to 150 Hz
4.9 m/s
Impact
147 m/s
2
, 3 times in each of X, Y and Z directions
resistance (*1)
Operating
Corrosive gas shall not be present.
atmosphere
Operating
2,000 m (6561'8") or less (*2)
altitude
Installation
Inside control panel (*3)
place
Over-voltage
ΙΙ or less (*4)
category
Degree of
2 or less (*5)
contamination
Notes:
*1 The criterion is shown in IEC61131-2.
*2 The module cannot be used in an environment pressurized above the
atmospheric pressure which can be generated around the altitude of 0 m. If the
module is used in such an environment, it may fail.
*3 The module can be used in any environment even outside the control panel as
far as the requirements of the ambient operating temperature, the ambient
operating humidity, etc. are satisfied.
*4 This indicates the section of the power supply to which the equipment is
assumed to be connected between the public electrical power distribution
network and the machinery within premises. Category ΙΙ applies to equipment
for which electrical power is supplied from fixed facilities.
The surge voltage withstand level for up to the rated voltage of 300V is 2500V.
*5 This index indicates the degree of conductive generating substances in the
environment in which the module is used. The degree of contamination 2 indicates
that contamination is caused by generation of only non-conductive substances.
In this degree, however, temporary conduction may be caused by accidental
condensation.
5.2 Input specifications
Item
Specification
Input method
DC input (using module power supply in common)
Number of input
1 point
Isolation method
Isolation with photocoupler
Rated input voltage
24 V DC
Rated input current
Approx. 4 mA
Operating voltage range
Same as module power supply
Max. simultaneous ON
100% (at 24 V DC)
input points
ON voltage/ON current
19 V or more/3 mA or more
OFF voltage/OFF current
11 V or less/1.7 mA or less
Input resistance
5.6 kΩ
Response
OFF→ON
1.5 ms or less (at 24 V DC)
time
ON→OFF
1.5 ms or less (at 24 V DC)
Common wiring method
1 point/1 common (Mutually exclusive output)
5.3 Output specifications
Item
Specification
Transistor output
Output method
(using module power supply in common) (sink)
Number of output
1 point
Isolation method
Isolation with photocoupler
Rated load voltage
24 V DC
Operating load voltage
Same as module power supply
range
Max. load current
0.1 A/point
0.2 A/1 common
Max. inrush current
0.4 A/10 ms
Leakage current at OFF
0.1 mA or less/30 V DC
Max. voltage drop at ON
1 V or less (max.)/0.1 A
Item
Number
OFF→ON
1.0 ms or less
Response
of times of
time
ON→OFF
1.0 ms or less
sweep
Surge suppression
Zener diode
Half amplitude
Common wiring method
1 point/1 common (Mutually exclusive output)
0.075 mm
10 times
Internal protection circuit none
Internal protection for
−
in each of
Please connect the fuse in the connected load
X, Y and Z
outputs
outside.
directions
Half amplitude
(for 80
5.4 Performance specifications
0.035 mm
min)
−
Item
20.4 to 28.8 V DC (24 V DC -15% to +20%)
Voltage
Ripple ratio: Within 5%
40 mA (when all points are ON)
Current
(Current consumption contains neither the input
Module
consumption
current nor the load current.)
power
supply
Initial current
70 mA
Max. allowable
momentary power
PS1:1 ms
failure period
Number of stations
4-, 8- or 16-point mode: 1 station
occupied
500 Vp-p
Noise durability
Noise width: 1µs Cycle: 25 to 60 Hz
(by noise simulator)
Withstand voltage
500 V AC for 1 min
10 MΩ or higher between primary area (external
Isolation resistance
DC terminal) and secondary area (internal circuit)
by 500V DC insulation resistance tester
Protection class
IP2X
I/O part connection method Connection with cable
Module installation method Can be installed in six directions
Flat cable for I/O (wire
AWG18 (34/0.18)
diameter)
0.07 kg (0.15 lbs)
Mass (weight)
(including 500 mm (19.69") flat cable dedicated to
CC-Link/LT and 500 mm (19.69") flat cable for I/O)
6.
Outside Dimensions
20(0.79")
24G
X0
Y0
Specification
「电器电子产品有害物质限制使用标识要求」的表示方式
Note: This symbol mark is for China only.
含有有害6物质的名称， 含有量， 含有部品
本产品中所含有的有害6 物质的名称， 含有量， 含有部品如下表
所示。
Specification
部件名称
外壳
可编程
控制器
印刷基板
本表格依据SJ/T 11364的规定编制。
○:表示该有害物质在该部件所有均质材料中的含量均在GB/T 26572
规定的限量要求以下。
×:表示该有害物质至少在该部件的某一均质材料中的含量超出GB/T
26572规定的限量要求。
This manual confers no industrial property rights or any rights of any other kind, nor
does it confer any patent licenses. Mitsubishi Electric Corporation cannot be held
responsible for any problems involving industrial property rights which may occur as
a result of using the contents noted in this manual.
Warranty
Exclusion of loss in opportunity and secondary loss from warranty liability
Regardless of the gratis warranty term, Mitsubishi shall not be liable for compensation to:
(1) Damages caused by any cause found not to be the responsibility of Mitsubishi.
(2) Loss in opportunity, lost profits incurred to the user by Failures of Mitsubishi products.
(3) Special damages and secondary damages whether foreseeable or not, compensation
for accidents, and compensation for damages to products other than Mitsubishi products.
(4) Replacement by the user, maintenance of on-site equipment, start-up test run and
other tasks.
For safe use
• This product has been manufactured as a general-purpose part for general
industries, and has not been designed or manufactured to be incorporated in a
device or system used in purposes related to human life.
• Before using the product for special purposes such as nuclear power, electric power,
aerospace, medicine or passenger movement vehicles, consult with Mitsubishi Electric.
12(0.48")
• This product has been manufactured under strict quality control. However
when installing the product where major accidents or losses could occur if the
product fails, install appropriate backup or failsafe functions in the system.
Country/Region Sales office/Tel
USA
MITSUBISHI ELECTRIC AUTOMATION, INC.
500 Corporate Woods Parkway, Vernon Hills,
IL 60061, U.S.A.
Tel : +1-847-478-2100/+1-847-478-2500 (NC)
Brazil
MITSUBISHI ELECTRIC DO BRASIL
COMERCIO E SERVICOS LTDA.
Avenida Adelino Cardana, 293, 21 andar,
Bethaville, Barueri SP, Brazil
Tel : +55-11-4689-3000
Germany
MITSUBISHI ELECTRIC EUROPE B.V.
– German Branch
Mitsubishi-Electric-Platz 1, 40882
Ratingen, Germany
Tel : +49-2102-486-0
UK
MITSUBISHI ELECTRIC EUROPE B.V. UK Branch
Travellers Lane, Hatfield, Hertfordshire,
AL10 8XB, UK
Tel : +44-1707-28-8780
Italy
MITSUBISHI ELECTRIC EUROPE B.V.
– Italian Branch
Centro Direzionale Colleoni - Palazzo Sirio,
Viale Colleoni 7, 20864 Agrate Brianza (MB), Italy
Tel : +39-039-60531/+39-039-6053-342
Spain
MITSUBISHI ELECTRIC EUROPE, B.V.
– Spanish Branch
Carretera de Rubi 76-80-AC.420, E-08190
Sant Cugat del Valles (Barcelona), Spain
Unit: mm(inches)
Tel : +34-935-65-3131/+34-935-65-2236
France
MITSUBISHI ELECTRIC EUROPE B.V.
– French Branch
25, Boulevard des Bouvets, 92741
Nanterre Cedex, France
Tel : +33-1-55-68-55-68
Czech Republic MITSUBISHI ELECTRIC EUROPE B.V.
Czech Branch
Avenir Business Park, Radicka 751/113e,
+24V
158 00 Praha5, Czech Republic
Tel : +420-251-551-470
Poland
Mitsubishi Electric Europe B.V. Polish Branch
ul. Krakowska 50, 32-083 Balice, Poland
Tel : +48-12-347-65-00
HEAD OFFICE : TOKYO BUILDING, 2-7-3 MARUNOUCHI, CHIYODA-KU, TOKYO 100-8310, JAPAN
When exported from Japan, this manual does not require application to the Ministry of Economy,
Trade and Industry for service transaction permission.
产品中有害物质的名称及含量
有害物质
多溴
铅
汞
镉
六价铬
多溴联苯
二苯醚
(Pb)
(Hg)
(Cd)
(Cr(VI))
(PBB)
(PBDE)
○
○
○
○
○
○
×
○
○
○
○
○
Country/Region Sales office/Tel
Russia
Mitsubishi Electric (Russia) LLC
52, bld. 1, Kosmodamianskaya emb.,
115054 Moscow, Russia
Tel : +7-495-721-2070
China
MITSUBISHI ELECTRIC AUTOMATION
(CHINA) LTD.
Mitsubishi Electric Automation Center,
No.1386 Hongqiao Road, Shanghai, China
Tel : +86-21-2322-3030
Taiwan
SETSUYO ENTERPRISE CO., LTD.
6F, No.105, Wugong 3rd Road, Wugu District,
New Taipei City 24889, Taiwan, R.O.C.
Tel : +886-2-2299-2499
Korea
MITSUBISHI ELECTRIC AUTOMATION
KOREA CO., LTD.
7F~9F, Gangseo Hangang Xi-tower A, 401,
Yangcheon-ro, Gangseo-Gu, Seoul, 07528, Korea
Tel : +82-2-3660-9530
Singapore
MITSUBISHI ELECTRIC ASIA PTE. LTD,
307 Alexandra Road, Mitsubishi Electric
Building, Singapore 159943
Tel : +65-6473-2308
Thailand
Mitsubishi Electric Factory Automation
(Thailand) Co., Ltd.
12th Floor, SV.City Building, Office Tower 1,
No. 896/19 and 20 Rama 3 Road, Kwaeng
Bangpongpang, Khet Yannawa,
Bangkok 10120, Thailand
Tel : +66-2682-6522~31
Indonesia
PT. Mitsubishi Electric Indonesia
Gedung Jaya 11th Floor, JL. MH. Thamrin
No.12, Jakarta Pusat 10340, Indonesia
Tel : +62-21-3192-6461
India
Mitsubishi Electric India Pvt. Ltd.
Gurgaon Head Office
2nd Floor, Tower A & B, Cyber Greens,
DLF Cyber City, DLF Phase - III,
Gurgaon - 122002, Haryana, India
Tel : +91-124-4630300
Australia
MITSUBISHI ELECTRIC AUSTRALIA PTY. LTD.
348 Victoria Road PO BOX11, Rydalmere,
N.S.W 2116, Australia
Tel : + 61-2-9684-7777
Specifications subject to change without notice.
Advertisement
