HannStar HQ171D Service Manual page 27

H a n n S t a r D i s p l a y C o r p .
Document Title
Document No.
1) MCU initialize.
2) Is the EPROM blank?
3) Program the EPROM by default values.
4) Get the PWM value of brightness from EPROM.
5) Is the power key pressed?
6) Clear all global flags.
7) Are the AUTO and SELECT keys pressed?
8) Enter factory mode.
9) Save the power key status into EPROM.
Turn on the LED and set it to green color.
Scalar initializes.
10) In standby mode?
11) Update the lifetime of back light.
12) Check the analog port, are there any signals coming?
13) Does the scalar send out an interrupt request?
14) Wake up the scalar.
15) Are there any signals coming from analog port?
16) Display "No connection Check Signal Cable" message. And go into standby mode after the message
disappear.
17) Program the scalar to be able to show the coming mode.
The information contained in this document is the exclusive property of HannStar Display Corporation. It shall not be
disclosed,distributed or reproduced in whole or in part without written permission of HannStar Display Corporation.
HQ171D_XY _HSM Page No. 27 27 / 87
Revision
07/08/09