New Call Indicator; O Ut -G Oing A Nnouncement I; Ntroduction - RCA 25205 User Manual

Connections and Setup

New Call Indicator

1. Press the Menu button.
2. Use the 5 or 6 button to scroll to PHONE SETTING.
3. Press the Sel/Save button.
4. Use the 5 or 6 button to scroll to NEW CALL LED.
5. Press the Sel/Save button.
6. Use the 5 or 6 button to select on or off.
NOTE: If you select ON, the New Call Indicator will flash after the phone receives a new
caller ID. If it is OFF, the New Call Indicator will stay at OFF status even if a new caller ID is
received.
7. Press the Sel/Save button to save. To start over, press the Exit button to return to the
PHONE SETTING menu.
Out-Going Announcement Introduction
There are many OGAs for each line and for different purposes.
DEFAULT:
PERSONAL:
ANNOUNCE
WORK HOURS:
AFTER HOURS:
1
The pre-recorded message "Please leave a message after the tone" is
an invite for the caller to leave message.
It is empty when powered up for the first time. You have to record it if
you don't want to use the DEFAULT OGA.
It is empty when powered up for the first time. You have to record
it ONLY: before using it for answering. When ANNOUNCE ONLY
is selected under CONFIG OGA, the unit will use this OGA as an
answering announcement and will not record incoming message.
It is empty when powered up for the first time. You have to record it
before using it for answering. When TIMED is selected under CONFIG
OGA, the unit uses WORK HOURS OGA and AFTER HOURS OGA in
accordance to the time that was programmed Work and After hours.
It is empty when powered up for the first time. You have to record
it before using it for answering. When TIMED is selected under
CONFIG OGA, unit uses WORK HOURS OGA and AFTER HOURS OGA in
accordance to the time that was programmed Work and After hours.