Sharp AR-RP6 Service Manual page 3

2. Remove the right cabinet.
Remove the screws and remove the right cabinet.
3. Remove the document glass and the right document
glass holder.
Remove the screws, remove the document glass from the copier, and
then remove the right document glass holder.
4. Attach the SPF glass holder.
Fit the SPF glass holder to the document glass.
Attach the document glass to the copier and fix it with the screws.
5. Attach the right cabinet.
Reattach the right cabinet to its original position and fix it with the
screws.
6. Cut out the cut-out portion.
Cut out the cut-out portion of the rear cabinet with nippers or the like.
At this time, be careful about the orientation of the nippers so that the
cut plane of the rear cabinet is flat.
7. Attach the automatic document feeder.
Insert the hinge portions of the document feeder into the mounting por-
tions of the copier by holding the feeder at an angle toward the rear
side.
AR-SP6/RP6 UNPACKING AND INSTALLATION
– 2 –