Subaru 2003 LEGACY Service Manual page 8

3) Camshaft oil seal installation:
Apply grease to the new oil seal lips and press onto
the front end of camshaft by using ST1 and ST2.
NOTE:
Use a new oil seal.
ST1 499587600 OIL SEAL INSTALLER
ST2 499597200 OIL SEAL GUIDE
ST1
4) Rocker cover installation:
(1) Install the gasket on rocker cover.
Install the peripheral gasket and ignition coil
gasket.
(2) Apply fluid packing to the indicated portion
on rocker cover.
Fluid packing:
Part No. 004403007
THREE BOND 1215 or equivalent
LH
RH
(3) Install the rocker cover on cylinder head.
Ensure the gasket is properly positioned during
installation.
5) Install the ignition coil.
6) Connect the ignition coil connector.
ST2
ME-00116
ME-00604
ME(H4DOSTC)-59
CAMSHAFT
7) Similarly, install the parts on right-hand side.
8) Install the belt cover No. 2 (RH).
Tightening torque:
5 N·m (0.5 kgf-m, 3.6 ft-lb)
9) Install the tensioner bracket.
Tightening torque:
25 N·m (2.5 kgf-m, 18.1 ft-lb)
10) Install the belt cover No. 2 (LH).
Tightening torque:
5 N·m (0.5 kgf-m, 3.6 ft-lb)
11) Install the crankshaft sprockets.
<Ref. to ME(H4DOSTC)-56, INSTALLATION,
Crankshaft Sprocket.>
12) Install the camshaft sprocket.
<Ref. to ME(H4DOSTC)-55, INSTALLATION,
Camshaft Sprocket.>
13) Install the timing belt assembly.
<Ref. to ME(H4DOSTC)-49, INSTALLATION, Tim-
ing Belt Assembly.>
14) Install the belt cover.
MECHANICAL
ME-00107
ME-00105
ME-00106