Subaru 2003 LEGACY Service Manual page 29

MECHANICAL
22) Apply fluid packing to the matching surfaces,
and then install the oil separator cover.
Fluid packing:
Part No. 004403007
THREE BOND 1215 or equivalent
23) Install the drive plate. (AT vehicles)
To lock the crankshaft, use ST.
ST 498497100 CRANKSHAFT STOPPER
Tightening torque:
7.2 N·m (7.3 kgf-m, 52.8 ft-lb)
24) Install the flywheel. (MT vehicles) <Ref. to CL-
20, INSTALLATION, Flywheel.>
25) Install the clutch disc and cover. (MT vehicles)
<Ref. to CL-15, INSTALLATION, Clutch Disc and
Cover.>
26) Installation of oil pump:
(1) Discard the front oil seal after removal. Re-
place with a new one using the ST.
ST 499587100 OIL SEAL INSTALLER
CYLINDER BLOCK
Fluid packing:
ME-00163
ST
ME-00136
Tightening torque:
NOTE:
• Do not forget to install the O-ring and seal when
installing the oil pump.
• Align the flat surface of oil pump's inner rotor with
crankshaft before installation.
ME-00164
ME(H4DOSTC)-80
(2) Apply fluid packing to the matching surface
of oil pump.
Part No. 004403007
THREE BOND 1215 or equivalent
(A) O-ring
(3) Apply a coat of engine oil to the inside of the
oil seal.
(4) Install the oil pump on cylinder block. Be
careful not to damage the oil seal during instal-
lation.
6.4 N·m (0.65 kgf-m, 4.7 ft-lb)
( A )
ME-00165
ME-00312