Sharp XE-A1BT Service Manual page 16

c. Test result print
When the test completion, following result is printed out
< XE-A147 >
A/D
1 HEAD VOLTAGE X.XXV
2 HEAD TEMP X.XXV
3 BBATTERY VOLTAGE X.XXV
4 BATTERY VOLTAGE X.XXV
5 BATTERY TEMP X.XXV
<XE-A137>
A/D
1 HEAD VOLTAGE X.XXV
2 HEAD TEMP X.XXV
3 BBATTERY VOLTAGE X.XXV
3-8) CLOCK TEST
a. Test Procedure
With the above key operation, the clock test is started.
The clock data is read from CPU and displayed by real time.
If count up is done correctly, the result is OK, push the [TL] key,
test will finish with OK status.
If not, push other than [TL] key, test will finish with NG status.
b. Display
Hour
Blink each 500msec
c. Test result print
When a test result is OK, following result is printed out
CLOCK
When a test result is NG, following result is printed out
CLOCK
Minute Second
OK
NG
3-9) Destination display / ROM version check
a. Test Procedure
With the above key operation, the Destination display / ROM
version check is started.
The CPU version and destination setting are read from CPU then
displayed. The destination code is as follows;
North America
Display
Print
If the displayed destination is correct, the result is OK, push the
[TL] key, test will finish with OK status.
If not, push other than [TL] key, test will finish with NG status.
* In case of check sum is not correct, even if [TL] key is pushed,
but, it may judged "NG". Because of OK/NG is automatically
judged by the program.
b. Display
<North America>
<EU>
<Japan>
c. Test result print
When a test result is OK, following result is printed out
When a test result is NG, following result is printed out
5-5
EU
0 1
U V
ROM ver Destination
DESTINATION U OK
ROM ver. 1.00
DESTINATION U OK
ROM ver. 1.00
Japan
2
J
code