The QuickLock Padlock Manual page 5

Connecting with Bluetooth

To connect the Padlock to the App, press "Add Device" on the App and then press the button on the Padlock.
The blue LED will begin to flash on the Padlock and then turn solid when the phone connects to the Padlock.
Within 15 seconds, a dialog box will pop up asking for a password. The default password for the Padlock is
12345678. It is recommended that you change the password immediately. (Warning: the password is only
stored on the Padlock and on the App. If the App is removed or replaced, the password will be deleted from
your phone and must be reentered. If you forget your password, the SafeTech support team will not be able to
recover it for you. To recover your password, you will need to send in your Padlock to be reprogrammed. This
service is not covered under warranty). If the App gets stuck verifying the password, refer to the next section
about pairing the SK-1 to your phone.
Pairing the Padlock to a Phone

For many phones the pairing step is completed by the phone automatically. If you are having trouble getting the
App to verify your password the first time you are using the App, it may because the Padlock is not properly
paired to your phone. To pair manual, open the App, press the button on the Padlock and press "Add Device"
on the App. Once the password dialog box pops up, pull down your phones Notification screen by swiping from
the top of the screen down. Look for a pairing request in the notifications. To pair, you will need to select the
notification and then press pair. You should now be able to type in the password and continue to the App
Unlock screen.