How To Operate - Ginnys 726925 User Manual

MAKING ICE:
Note:
This machine normally produces 9 pieces of ice with each cycle.
Expect it to take 20 minutes for the first cycle. After that,
it should take approximately 10 minutes per cycle. For the first 3
cycles, the ice may be small and irregular in size.
1. Ensure the drain stopper is in place.
2. Fill the reservoir with cold water up to the basket line (we recommend
using filtered water). Ensure the water level in the reservoir is not over
the bottom of the ice basket.
3. Close the lid, and plug the ice maker into an electrical outlet.
4. Press ON/OFF to begin the ice making cycle.
5. While the ice maker is on, regularly check the ADD WATER indicator. If the
water pump can't inject water, the ice maker will stop automatically and
the ADD WATER indicator will come on. Turn the unit off using ON/OFF,
then fill the reservoir again. Allow 3 minutes for the refrigerant to settle,
then press ON/OFF to restart the ice making cycle.
6. When the ice basket is full, the ICE FULL indicator light will turn on. At this
point, you should remove some of the ice with the scoop. (When there
is room in the basket, the machine can resume making ice.)
7. Press ON/OFF to stop the ice maker. Unplug when finished using.
Tip:
This unit is not a freezer, it will not keep ice frozen indefinitely.
If not immediately using the ice, remove it and store in a freezer
or cooler.
8

HOW TO OPERATE

Pinterest.com/GinnysBrand