Related Manuals for Envirco MAC 10 LEAC
Summary of Contents for Envirco MAC 10 LEAC
- Page 1 MAC 10 LEAC ® Fan Filter Unit Standard, RSR, & RSRE Models INSTALLATION, OPERATION & MAINTENANCE MANUAL ENVIRCO Technical Support: 800-884-0002...
-
Page 2: Table Of Contents
Unit Control Box .......................11 Troubleshooting ....................... 12 MAC 10 LEAC Wiring Diagrams..................13 MAC 10 LEAC Replacement Parts List ................14 Limited Warranty ......................15 Testing ..........................15 Innovators in Clean Air Technology | www.envirco.com | Installation, Operation, & Maintenance... -
Page 3: Important Information
Date ______________________________________________________________________________________________ Airflows per Certification _______________________________________________________________________________ ■ Contact Information ENVIRCO USA 101 McNeill Road Sanford, NC 27330 Tel: (919) 775-2201 Tel: (800) 884-0002 Fax: (800) 458-2379 Email: info@envirco.com Innovators in Clean Air Technology | www.envirco.com | Installation, Operation & Maintenance... -
Page 4: Critical Operations Of The Mac 10
Note: A “Z” in the part number indicates that the unit is special. This may indicate a size change from standard or a special filter. Please contact the factory for part numbers if this is the situation. Innovators in Clean Air Technology | www.envirco.com | Installation, Operation, & Maintenance... -
Page 5: Installation
■ Installation Note: The MAC 10 LEAC Fan Filter Unit is completely assembled at the factory with the exception of the optional ¼” (0.64 cm)-20 eyebolts, which can be used when hanging the unit from an overhead structure. Step 1. Carefully remove the unit from the shipping carton and inspect for any damage that may have occurred during transportation. -
Page 6: Cleaning The Prefilter (Foam)
Step 4. After removing the new G4 pleated prefilter from the box, remove the die cut slots from the beverage board frame and install on prefilter bracket. Step 5. Complete by reversing the above steps. Innovators in Clean Air Technology | www.envirco.com | Installation, Operation, & Maintenance... -
Page 7: Service: Removal And Replacement Of Standard Filters
2X4 & 2X3.5 = 10X; 2X3 & 2X2 = 8X STD FILTER Ø5/32 RIVET (6X) (NONE ON 2X2) Figure 4: Standard Filter Replacement Figure 6 - Standard Filter Replacement Innovators in Clean Air Technology | www.envirco.com | Installation, Operation & Maintenance... -
Page 8: Service: Removal And Replacement Of Rsre Filters
(DOWN STREAM) PERFORATED DIFUSSER SCREEN HARDWARE: SCREEN #10-32x1/2 PHP SCREW #10 NYLON WASHER SCREEN HARDWARE PERFORATED DIFUSSER SCREEN Figure 5: RSRE Filter Replacement Figure 7 - RSRE Filter Replacement Innovators in Clean Air Technology | www.envirco.com | Installation, Operation, & Maintenance... -
Page 9: Service: Standard Motor Removal And Installation
MOTOR/BLOWER ASSEMBLY VENTURI RING MOTOR/BLOWER MOUNTING BRACKET FILTER (STD) FILTER PLENUM (RSRE - NOT SHOWN) LID PANEL ASSEMBLY Figure 6: Standard/RSR Motor Replacement Figure 9.1 - Motor Replacement Innovators in Clean Air Technology | www.envirco.com | Installation, Operation & Maintenance... -
Page 10: Service: Rsre Motor Removal And Installation
M6x16mm PHP SCREW MOTOR MOUNTING BRACKET M6 LOCKWASHER CABLE TIE (FOR MOTOR CABLE) MOTOR/BLOWER ASSEMBLY MOTOR/BLOWER ASSEMBLY CONNECTOR PREFILTER BRACKET Figure 7: RSRE Motor Replacement Figure 9.2 - Motor Replacement Innovators in Clean Air Technology | www.envirco.com | Installation, Operation, & Maintenance... -
Page 11: Unit Control Box
Periodic airflow velocity readings (Per I.E.S. T. Specifications) should be conducted to determine the filter condition and appropriate fan speed setting. HIGH MEDIUM ON/OFF SWITCH 3 SPEED SWITCH ELECTRICAL ENTRANCE Figure 8: 3 Speed Switch Adjustment Figure 3 - Speed/Airflow Adjustment Innovators in Clean Air Technology | www.envirco.com | Installation, Operation & Maintenance... -
Page 12: Troubleshooting
Step 4. Conduct smoke and photometer test on HEPA filter. Seal or replace HEPA filter as necessary. Contact Technical Support at: ENVIRCO 101 McNeill Road Sanford, NC 27330, USA Tel: (800) 884-0002 Fax: (800) 458-2379 Email: info@envirco.com Innovators in Clean Air Technology | www.envirco.com | Installation, Operation, & Maintenance... -
Page 13: Mac 10 Leac Wiring Diagrams
I n s t a l l a t i o n , O p e r a t i o n , & M a i n t e n a n c e M a n u a l ■ MAC 10 LEAC Wiring Diagram Figure 9: Wiring Diagram Innovators in Clean Air Technology | www.envirco.com | Installation, Operation & Maintenance... -
Page 14: Mac 10 Leac Replacement Parts List
Optional Accessories: • Fluorescent lighting • Ionizing bar • ULPA Filter (Standard and RSR) • A/C intake collar: 20x20 (10” /254mm) • 20x20 (12” /304.8mm) • 20x20 (14” /355.6mm) Innovators in Clean Air Technology | www.envirco.com | Installation, Operation, & Maintenance... -
Page 15: Limited Warranty
WARRANTIES, EXPRESS OR IMPLIED, INCLUDING, BUT NOT LIMITED TO, ANY IMPLIED WARRANTIES OF MERCHANTABILITY, NON-INFRINGEMENT OR FITNESS FOR A PARTICULAR PURPOSE WHICH ARE HEREBY DISCLAIMED TO THE EXTENT PERMITTED BY APPLICABLE LAW. Innovators in Clean Air Technology | www.envirco.com | Installation, Operation & Maintenance... - Page 16 » MAC-T Ceiling Grid System » VOR Vertical Flow Surgery Isolator ENVIRCO MAC 10 is a registered trademark of ENVIRCO, USA. Specifications subject to modifications or changes without notice. US patents 4,560,395 and 5,470,363. Other patents issued and pending in foreign countries. ENVIRCO ®...
Need help?
Do you have a question about the MAC 10 LEAC and is the answer not in the manual?
Questions and answers