Controlling Voicings; Controlling Lipsync - Lyngdorf Audio MP-50 User Manual

Controlling Voicings

Command !RPVOIS?<CR> is used to find out the list of selectable voicings along with their
names. For example, a response for !RPVOIS<CR> is:
!RPVOICOUNT(7)<CR>
!RPVOI(0)"Neutral"<CR>
!RPVOI(1)"Music"<CR>
!RPVOI(2)"Music II"<CR>
!RPVOI(3)"Relaxed"<CR>
!RPVOI(4)"Tilt"<CR>
!RPVOI(5)"Action"<CR>
!RPVOI(6)"Action+Movie"<CR>
It can be seen from the response that there are 7 voicings, named "Neutral," "Music," "Music
II," "Relaxed," "Tilt," "Action," and "Action+Movie."
Command !RPVOI?<CR> is used to find out which voicing is currently selected. The
response for this command is !RPVOI(X)"NAME"<CR> where X is the index of the currently
selected voicing (0 is the first index) and NAME is the name of the currently selected voicing.
This response is sent automatically whenever the current voicing is changed if feedback
level is 1 or higher.
Commands !RPVOI+<CR> and !RPVOI-<CR> are used to select next or previous voicing.
Command !RPVOI(X)<CR> is used to select a specific source. The X in the command can
be any index from the list of voicings.

Controlling Lipsync

Command !LIPSYNC?<CR> is used to find out the current value of the lipsync trim. The
response for this command is !LIPSYNC(X)<CR> where X is the current lipsync trim in
milliseconds.
Commands !LIPSYNC+<CR> and !LIPSYNC-<CR> are used to adjust the lipsync trim value
by 5ms or -5ms, respectively. Command !LIPSYNC(X)<CR> is used to set the lipsync trim
directly. The valid value range for this command needs to be fetched from the MP-50 (see
below).
Please note that the valid range to adjust the lipsync delay is retrieved with
the!LIPSYNCRANGE? command, returning minimum and maximum value in ms.
Getting main zone video and audio status
19
Model MP-50 – External Control Manual