Pin; Pin Reset - Sprint Booster v3 Ultimate Control User Manual

Once you enable the Pedal Lock mode the car will not be
able to accelerate when you press the accelerator pedal and will stay
on idle.
The PIN should be entered every time you need to activate-deactivate
the Pedal Lock mode. You have the option to use different PIN
Every time (not recommended). The 3 digit PIN you use to activate the
Pedal Lock mode is the one you need to use to deactivate it every time.
Make sure you have memorized the PIN before activating the Pedal
Lock mode.
In case you forgot your PIN, you need to follow the procedure to reset
the PIN stored.
Sprint Booster has a PIN reset option through a time delay process:
1. Turn On the engine to activate the power on the device.
2. When the device is in Lock mode there will be an
Display.
3. Wait for 35 minutes (with power On) without pressing the pedal.
4. After the time delay limit (35') the device will reset the password, the
digit will blink for a few seconds on the LED display and Pedal Lock
mode will be deactivated (Will go back to Off mode).
-During the 35' reset process the pedal should not be
pressed.If the pedal is pressed during this time ,
the time delay limit will be renewed to another 35'.
-Always make sure you have memorized the PIN before
activating the Pedal Lock mode in order to avoid the time
delay process to reset the PIN. In case you have forgot your
PIN and have no time to follow this procedure , you will need
to completely uninstall the device from the Pedal.
In case you activate the Pedal Lock mode and disconnect the
selector switch from the device, the 35' reset option does not
apply. In order to be able to reset the PIN you need to have
the selector switch connected to the device.
Pedal Lock mode

PIN

PIN reset

on the LED