— Rev N PS48/PS80 Advantage Series Salt Based Water Softeners Page 3 Table of Contents Table of Contents ............3 Product Operation and Specifications .
— Rev N PS48/PS80 Advantage Series Salt Based Water Softeners Page 4 Product Operation and Specifications Specification Description 12-18 GPM (depending on model) Rated Service Flow Minimum Working Pressure 25 PSI 80 PSI Maximum Working Pressure Maximum Vacuum 5 inch/127 mm Hg 36°F - 100°F...
— Rev N PS48/PS80 Advantage Series Salt Based Water Softeners Page 5 Complete Parts List Note: Pelican Water Systems supplies the parts below to accommodate a variety of water supply lines. Table 1: Parts List Part Description Qty. Part Description Qty.
DELAND, FL 32724 CANNO T BE REPRO DUCED O R USED TO Water Systems 1-877-842-1635 MANUFACTURE ANYTHING SHO WN O R REFERRED INSTALLATION DIAGRAM TO WITHO UT DIRECT WRITIEN PERMISSIO N FROM wm1. pe l i canwater. com PELICAN WATER SYSTEMS. PS48/80...
— Rev N Page 7 PS48/PS80 Advantage Series Salt Based Water Softeners Pre-Installation Bypass Valve Installation Front View Bypass Valve Clip Electronic Head Softener Tank Figure 2 If the Red Clips are in the slots (female opening of Electronic Head) remove them. Push the male O- Ring side of the Bypass Valve into the female opening of the Electronic Head.
— Rev N Page 8 PS48/PS80 Advantage Series Salt Based Water Softeners Installation Install Electronic Head MENU Electronic Head Distributor Tube Red Clips Bypass Valve Tail Adaptors Figure 3 1. Level the Pelican Softener Tank. Notice: If the tank is not level, lift the tank straight up 6 inches and tap it on the ground until the tank stands vertical.
— Rev N Page 9 PS48/PS80 Advantage Series Salt Based Water Softeners Final Setup and Installation Wall Outgoing Incoming Bypass Water to Water Valve Drain Line Barb House Supply Safety Valve Electronic Head Brine Tank Softener Tank Figure 4 9. Attach the black Brine Tank hose to the connection on the top of the Electronic Head by removing the black compression nut.
— Rev N Page 10 PS48/PS80 Advantage Series Salt Based Water Softeners Programming the Electronic Head Note: Remove protective film from electronic head screen. MENU Step 1: Setting the Date & Time 1. Press and hold the MENU button until you hear the beep to unlock.
— Rev N PS48/PS80 Advantage Series Salt Based Water Softeners Page 11 IMPORTANT! You will need to manually regenerate (Regen Now) your system prior to use. To do so follow the programming below. You will not be able to use water for approximately 2 hours during this process.
— Rev N PS48/PS80 Advantage Series Salt Based Water Softeners Page 12 Troubleshooting Problem Solution Water leaking at the top of the tank around the head. You may need to turn the head to tighten it. The tank head is installed hand-tight, do not overtighten the head (just turn it snug).
— Rev N PS48/PS80 Advantage Series Salt Based Water Softeners Page 13 Warranty Pelican Limited Lifetime Warranty Pelican Water ("Pelican") warrants to the end user ("customer") that its tanks (13" & smaller), in/out heads, bypass's, fittings, Natursoft media and housings ("Covered Items") will be free from defects in material and workmanship under normal use and service for the life of the system.
— Rev N PS48/PS80 Advantage Series Salt Based Water Softeners Page 14 Warranty Registration Form Send in this Warranty Registration Form to validate your warranty or visit www.PelicanWater.com to complete warranty registration form online. Pelican Warranty Registration Form Date Item(s) were Received:...
Need help?
Do you have a question about the PS48 and is the answer not in the manual?
Questions and answers