Epson DM-D110 User Manual page 6

English
When using the USB cable of DM-D110/DM-D210
❏
Do not connect to a USB connector of TM printer or USB hub which has
limited power supply capacity. Doing so will exceed the power supply
capacity and cause the TM printer or USB hub to break down.
❏
USB RS-232 Convert Driver (DM-D110(USB)_VCPdriver_Ver.2.xx.zip) is
required to use DM-D110/DM-D210. The driver is not included with DM-
D110/DM-D210. Download it from the following URL, and install it before
use:
http://www.epson.jp/dl-sd/
After installing the above driver, the computer will recognize DM-D110/DM-
D210 as a USB device and add a virtual COM port. This product will be
recognized as a serial device and can be used via a COM port.
Note:
If you use a TM-i series or TM-DT series printer, you do not need to install USB RS-232
Convert Driver.
Changing the Orientation of the Display Unit
The angle and direction of the display unit can be changed by holding the struts
with your hand while moving the display unit. The display unit will move with
only light pressure, so do not apply more pressure once the unit stops moving.
Applying excess force to move the display unit may cause damage.
When installed in the TM printer, there may be situations where the display unit
cannot be turned to the desired direction. In these situations, remove the customer
display and base unit, then adjust the position of the lug in the base unit before
reattaching.
See Illustration D.
DIP Switches
The DIP switches configure the communication settings and whether a self-test is
required.
See Illustration E.
CAUTION:
Do not remove the DIP switch cover until after turning the power off. Removing
the cover while the power is turned on may damage the device.
Remove the cables from the computer and remove the cover of the dip
switch. If the cables are still connected to the computer during operation, this
product may break down.
6 DM-D110/D210 User's Manual