Download Print this page

My ADT Ademco Vista-10P Quick Manual

Quick Guide:

For a detailed review of the entire system, please view the

Arm and Disarm

Arm:

To arm in STAY mode when you are not leaving the premises, enter your [security code] + [STAY].



To arm in AWAY mode when you are leaving the premises, enter your [security code] + [AWAY].



To arm in MAX when there is no entry delay, enter your [security code] + [MAX]



Disarm:

To disarm, enter your [security code] + [OFF].



Ademco Vista-10P

Ademco Vista – 10P system manual.

Table of Contents

Do you have a question about the Ademco Vista-10P and is the answer not in the manual?

Page 1 Quick Guide: Ademco Vista-10P For a detailed review of the entire system, please view the Ademco Vista – 10P system manual. Arm and Disarm Arm: To arm in STAY mode when you are not leaving the premises, enter your [security code] + [STAY].
Page 2: Change Time And Date
Battery The Ademco Vista 10P operates on a UB 1270 battery.  Loss of AC power and use of backup battery power is indicated by NO AC.  A low battery condition is indicated by BAT.  For instructions on replacing your battery, please visit our Battery Replacement Page.
Page 3: Security Codes
Security Codes Your system allows additional security codes for use by other users, however only the Master user can assign user codes to users. To add a user code, enter your [Master code] + [8] + [new user number] + [ 4-digit new user’s code]. ...
Page 4: Trouble Conditions
Trouble Conditions Trouble conditions are issues that require your attention and are indicated on your panel’s display by the word CHECK + zone number and accompanied by beeping from the touchpad. To silence Trouble Conditions beeping, check that the zone’s protected areas are closed and secure. ...