My ADT Ademco Vista-10P User Manual

Table of Contents

Download this manual

Ademco Vista-10P

Low Battery Warning

When the keypad displays BAT with no zone number, this indicates that the system back up battery needs to recharge. If

AC power is out, the security system may shut down once the battery is below the operating level. When AC power is

restored, the panel recharges the battery. If the warning exists more than 24-48 hours after AC power is restored, it is

time to replace it.

To silence trouble beeps due to a BAT alert, press [1 OFF]. The low battery condition will remain on until the battery is

recharged or replaced.

Order your system battery under My Alarm > Order Equipment > Replacement Batteries

or purchase one at a local battery supply store. When purchasing a replacement battery

from a battery retailer or battery supply store, it is helpful to take the old one to ensure

the replacement battery is the same voltage and amperage, as well as the same size. You

can also call ADT Customer Care to order your battery.

Table of Contents

Do you have a question about the Ademco Vista-10P and is the answer not in the manual?

Page 1 Ademco Vista-10P Low Battery Warning When the keypad displays BAT with no zone number, this indicates that the system back up battery needs to recharge. If AC power is out, the security system may shut down once the battery is below the operating level. When AC power is restored, the panel recharges the battery.
Page 2 Locating Control Panel Box The battery control panel box is typically located inside a closet, garage or attic. Please note: the control box is different from the panel keypad that is used to arm and disarm the security system. Install New Battery 1.
Page 3 5. Installing New Battery Place the new battery inside the control panel box. 1. If the replacement battery has plastic terminal protectors, remove them before connecting the wires to the battery. 2. Connect the red wire to the red or (+) terminal of the new battery by pushing the connector firmly onto the terminal.
Page 4 1. Enter the 2-digit hour setting. 2. Enter the 2-digit minute setting. 3. Press [1] for PM or [0] for AM. 4. Enter the last two digits of the current year. 5. Enter the 2-digit month setting. 6. Enter the 2-digit day setting. 3.
Page 5 5. Safety Warnings & Hazards Do not throw the battery in fire to heat the battery. The battery may burst or generate a toxic gas if placed in contact with fire. Warning: the battery contains diluted sulfuric acid, a very toxic substance. If the battery leaks and the liquid spills on skin or clothing, immediately wash it off with plenty of clean water.