Table of Contents
Advertisement
4. Line up the mounting screw with the camera's tripod socket. Use a
flat head screwdriver to tighten the mounting plate to the camera.
Mounting screw
1/4-20 tripod
mount
5. Pull out on the housing's ON/OFF, Shutter Speed, and Exposure
Compensation knobs to move them out of the way.
6. Insert the Mounting Plate into the corresponding slot on the inside
bottom of the housing. Rotate the front aperture knob slightly to
assist Gear Ring engagement with housing gear. Slowly push the
camera all of the way forward until the back of the Mounting Plate is
flush with the back of the housing mount.
7. Check the Gear Ring. If it has slipped backwards slightly, gently
push the top forward to engage with the gearing in the front of the
housing.
8. Orient the On/OFF control so that the legs of the "U" are on either
side of the camera lever.
The camera's Aperture Ring does not rotate 360º. Do not force
»
the control to rotate past its natural stop. Forced over-rotation
may damage the housing's gearing.
10
Camera tripod
socket
FRONT
Advertisement
Table of Contents
