Graco AFFIX Owner's Manual page 18

GB EN
GB
Always keep this Owner's Manual with the booster seat. Provisions are made
lap belt portion MUST pass under the armrests and
on the bottom of the seat shell.
be positioned low on the hips.
European Standard
Belt MUST NOT be twisted.
Your booster seat has been approved to European Standard ECE R44.04
24
If the belt lays across child's neck, head or face, readjust head support
Universal Group 2,3 15-36kg
height. Follow instructions, "Adjusting the Head Support" .
25
An approved number is attached to the seat shell and must not be removed.
Adjusting the Head Support
BEFORE adjusting the head support height, have your child lean
belts, approved to ECE Regulation No.16 or other equivalent standards.
forward slightly.
26 Squeeze the red adjustment button on top of seat and pull back support up
until it snaps into one of the 6 height positions.
27
To lower, squeeze red adjustment button and push down.
CHECK to make sure it is securely snapped into one of the 6 height
positions by pulling up on head support.
28
Attach connectors to vehicle lower anchors.
29
NEVER put two connectors on one vehicle anchor.
30
retain the restraint during an impact, when it is not being used.
31
32
To remove booster, lift release levers on sides of booster and pull slightly
away from seat.
33
Push connector in, lift connector up and pull out (away from anchor point).
Repeat on other connector.
12
18
18
li
IT
w
ar
E
sh