ASROCK X99 Extreme6/ac Manual page 7

* There are two LEDs on each LAN port. Please refer to the table below for the LAN port LED indications.
ACT/LINK LED
SPEED LED
LAN Port
Activity / Link LED
Status Description
Off No Link
Blinking Data Activity
On Link
** If you use a 2-channel speaker, please connect the speaker's plug into "Front Speaker Jack". See the table below
for connection details in accordance with the type of speaker you use.
Audio Output Front Speaker
Channels (No. 7)
2
4
6
8
To enable Multi-Streaming, you need to connect a front panel audio cable to the front
panel audio header. After restarting your computer, you will find the "Mixer" tool on your
system. Please select "Mixer ToolBox"
click "ok". Choose "2CH", "4CH", "6CH", or "8CH" and then you are allowed to select
"Realtek HDA Primary output" to use the Rear Speaker, Central/Bass, and Front Speaker,
or select "Realtek HDA Audio 2nd output" to use the front panel audio.
*** The eSATA connector supports SATA with cables within 1 meters. The SSATA3_3 connector is
shared with the eSATA port
Speed LED
Status
Off
Orange
Green
Rear Speaker
(No. 5)
V --
V V
V V
V V
, click "Enable playback multi-streaming", and
X99 Extreme6/ac / X99 Extreme6
Description
10Mbps connection
100Mbps connection
1Gbps connection
Central / Bass Line In
(No. 4) (No. 6)
--
--
V
V
--
--
--
V
5