Axor 38111181 Installation Instructions / Warranty

Axor - hansgrohe, inc. faucet installation instructions / warranty

Advertisement

Quick Links

Installation Instructions / Warranty
Axor Citterio/Steel/Uno
38111181

Advertisement

Table of Contents
loading

Summary of Contents for Axor 38111181

  • Page 1 Installation Instructions / Warranty Axor Citterio/Steel/Uno 38111181...
  • Page 2: Technical Data

    Axor Citterio/Steel/Uno Wall-mount single control lavatory mixer rough 31111181 Technical Data Flow Rate Recommended pressure Recomended hot water temp. 10 Hot and cold inlet ports *Please know and follow all applicable local codes when setting the temperature on the water heater.
  • Page 3: Installation Considerations

    Installation Considerations • Save time and frustration: plan the installation of both the faucet and the lavatory carefully. • For best results, this unit should be installed by a licensed, professional plumber. • Flush the hot and cold supply lines thoroughly, according to these installation instructions. Damage to the valve cartridge caused by debris is not covered by the Hansgrohe warranty.
  • Page 4: Installation Instructions

    spout outlet plug Installation Instructions This valve can be installed so that the handle is either to the right or to the left of the spout. This decision must be made prior to installation, as it cannot be changed at a later date without re- plumbing.
  • Page 5 Install the grommets to the nailing in flanges on the valve body. If space permits, screw or nail the flanges to stud or header board to support the valve. Flush the Valve Remove the protective caps. Use a 17 mm deep socket wrench to remove the spout outlet plug.
  • Page 6 Use a 7 mm deep socket wrench to remove the cartridge cover. Remove the flush insert. Turn the flush insert 180 Replace the flush insert and the cartridge cover. Tighten the cartridge cover with the deep socket wrench. Turn on the water again and flush for another 5 minutes.
  • Page 7: Limited Lifetime Consumer Warranty

    Cleaning Recommendation for Hansgrohe Products Modern sanitary faucetry and shower fixtures consist of very different materials to comply with the needs of the market with regard to design and functionality. To avoid damage and returns, it is necessary to consider certain points when cleaning: Cleaning materials for faucets and shower products: Acids are necessary ingredients of cleaning materials for removing lime.
  • Page 8 (i) for 1 year, with respect to Interaktiv and Retroaktiv products, and (ii) for 5 years, with respect to AXOR, ShowerPower and Pharo products. THIS WARRANTY DOES NOT COVER, AND HANSGROHE WILL NOT PAY FOR: Conditions, malfunctions or damage not resulting from defects in material or workmanship.

This manual is also suitable for:

Citterio 39115xx1Citterio 39116xx1Steel 35115801Steel 35116801Uno 38117xx1Uno 38118xx1

Table of Contents