Summary of Contents for Generac Power Systems ST20
Page 1
Owner’s Manual Water Pump Model CW15 Model ST20 Model Number Serial Number www.generac.com or 1-888-436-3722...
Page 2
WARNING! California Proposition 65 Engine exhaust and some of its constituents are known to the state of California to cause cancer, birth defects, and other reproductive harm. WARNING! California Proposition 65 This product contains or emits chemicals known to the state of California to cause cancer, birth defects, and other reproductive harm.
Thank you for purchasing this water pump manufactured 1-888-436-3722, or on the internet at www.generac.com. by Generac Power Systems, Inc. This is a high perfor- Record model and serial number of unit on front cover for mance, air-cooled, engine-driven water pump that oper- future reference and/or service inquiries.
Page 6
Introduction This page intentionally left blank. Water Pump...
Safety Section 2 2.1 — S AFETY ULES Throughout this publication, and on tags and decals affixed to the water pump, DANGER, WARNING, CAU- TION and NOTE blocks are used to alert personnel to Hearing Protection special instructions about a particular operation that may be hazardous if performed incorrectly or carelessly.
Page 8
Safety 2.1.1 — Exhaust Hazards • DO NOT touch hot parts and AVOID hot exhaust gases. • Allow equipment to cool before touching. Carbon monoxide produced during use can • Keep at least five (5) feet (152 cm) of clearance on all kill in minutes.
Page 9
Safety • DO NOT pump chemicals or flammable liquids, such 2.1.6 — Fall Hazard as fuel, or fuel oils. • Reflective exhaust heat may damage the fuel tank, causing fire. Keep at least 5 feet of clearance on all Use of water pump can create puddles sides of the pump for adequate cooling, maintenance, and slippery surfaces.
Page 10
Safety 2.1.10 — Splash Hazards Risk of eye injury. Spray can splash back or propel objects. • Always wear safety goggles when using this equip- ment or in vicinity of where equipment is in use. • Before starting the water pump, be sure you are wear- ing adequate safety goggles.
J - Air Filter - Protects engine by filtering dust and the suction hose. debris out of the intake air. Y - Filter Basket - Used to keep debris out of the pump. Figure 3-1. ST20 Features and Controls Water Pump...
Page 12
General Information Figure 3-2. CW15 Features and Controls V U T Figure 3-3. Features and Controls Water Pump...
General Information 3.2 — P If you are aware of any of the following symptoms, have RODUCT PECIFICATIONS your engine inspected and repaired by your servicing dealer: Model CW15K ST20K • Hard starting or stalling after starting Flow Rate (GPM / LPM) 80/303 158/598 •...
Page 14
General Information This page intentionally left blank. Water Pump...
Set-up Section 4 4.1 — A SSEMBLY Read entire operator’s manual before you attempt to assemble or if you have any problems with the assembly of your water pump, please call Generac Customer Ser- vice at 1-888-436-3722. When calling for assistance, please have the model and serial number from the data tag available.
Set-up 4.2 — A NGINE 1. Place water pump on a flat, level surface. Fuel and its vapors are extremely flamma- 2. Clean area around oil fill and remove ORANGE oil fill ble and explosive. Fire or explosion can cap/dipstick. cause severe burns or death.
Set-up 4.4 — C 4. Attach the filter to the suction hose by inserting the ONNECT UCTION AND barb end into the suction hose and securing with a ISCHARGE hose clamp. Then attach the filter end (Figure 4-8). 1. Attach and thread a gasket and hose barb to each of the threaded flanges using a hose nut (Figure 4-6).
Page 18
Set-up This page intentionally left blank. Water Pump...
Operation Section 5 5.1 — O PERATION If you have any problems operating your water pump, please call Generac customer service at 1-888-436-3722. 5.2 — WATER PUMP OCATION 5.2.1 — Clearances and Air Movement 5 Foot Minimum Running engine gives off carbon monoxide, an odorless, colorless, poisonous gas.
NOTE: For the ST20K model, pumping water with sol- 5.4.2 — Starting the ST20 Water Pump ids larger than .25" can damage the pump and void 1. Move fuel valve lever (A) to ON position (Figure 5-4).
Correct any issues before operating the pump. Improper maintenance will void the pump's warranty. Figure 5-5. Start the ST20 Water Pump NOTE: It is normal for the Water Pump to fluctuate speed while the system is self priming due to air Figure 5-6.
Page 22
Operation This page intentionally left blank. Water Pump...
Maintenance Section 6 6.1 — M 6.2 — M AINTENANCE ECOMMENDATIONS AINTENANCE CHEDULE Regular maintenance will improve the performance and Follow the hourly or calendar intervals, whichever occurs extend the life of the water pump. See any qualified first. More frequent service is required when operating in dealer for service.
Maintenance 6.4 — Outdoor temperatures determine the proper oil viscosity WATER PUMP AINTENANCE for the engine. Use the chart to select the best viscosity for the outdoor temperature range expected. 6.4.1 — Clean Debris Daily or before use, clean accumulated debris from water pump.
• Used motor oil has been shown to cause skin cancer in certain laboratory animals. • Thoroughly wash exposed areas with soap and water. Figure 6-4. ST20 Oil Drain Plug KEEP OUT OF REACH OF CHILDREN. • Don’t pollute. Conserve resources. Return used oil to 6.9 —...
Storage”. AIR CLEANER SCREW Fuel and its vapors are extremely flam- mable and explosive. Fire or explosion Figure 6-6. Service the ST20 Air Cleaner can cause severe burns or death. WHEN STORING FUEL OR EQUIPMENT WITH FUEL 6.10 — S...
Maintenance There is no need to drain gasoline from the engine if a 6.13 — O THER TORAGE NSTRUCTIONS fuel stabilizer is added according to instructions. Run the 1. DO NOT store fuel from one season to another engine for 2 minutes to circulate the stabilizer throughout unless it has been treated as described in Protect the fuel system.
Page 28
Maintenance This page intentionally left blank. Water Pump...
Troubleshooting Section 7 7.1 — T ROUBLESHOOTING UIDE PROBLEM CAUSE CORRECTION 1. Air leak in suction hose. 1. Make sure suction hose is double clamped at joints, clamps are tight, fittings have thread compound and are tight, with no nicks or cuts in hose. 2.
Page 30
Troubleshooting This page intentionally left blank. Water Pump...
Need help?
Do you have a question about the ST20 and is the answer not in the manual?
Questions and answers