Aqualtis Innovations - Hotpoint AQ113F497EUK Service Information

Indesit Company

AQUALTIS INNOVATIONS

Machine Door
The door of the machine is a single assembly consisting of the door lock, hinges, display board, the
cable to the power module and the door.
NOTE: - The door assembly replaces the control panel on conventional machines and includes all the
machines controls and the dispenser which can only be filled with the door assembly open.
Door Opening
The machine has a door lock, which includes an electrical solenoid. This means that the door can be
opened as soon as the cycle has finished and the drum is stationary.
The new door lock assembly with the emergency opening cord.
NOTE: - If the machine is stopped mid cycle it may not be possible to open the door without setting a
drain cycle to enable to door to be opened. Also if there is a power cut in the middle of a cycle it may
not be possible to open the door until the power is restored.
It is possible, however, to open the door in an emergency. Check the water level is below the door.
Remove the plinth and pull the emergency cord twice, two clicks will be heard. The door should now
open.
Pressure System
A linear pressure switch is used but the pressure chamber is part of the tank assembly and cannot be
removed.
Pressure pipe spigot
Service Manual UK
15 of 33
English