Table of Contents
Advertisement
4) Press " Mode Button " ( 3-5, Fig. 1) for scrolling more
display function as follows.
Here will show the emissivity data. (The
default emissivity is 0.95.)
Press Mode key ( 3-5, Fig. 1 ) for the
Maximum (MAX), Minimum (MIN), Different
between MAX and MIN (DIF) and Average
(AVG) modes. During the measurement, the
special modes reading will be displayed
beside the mode icon.
Press " Up Button " ( 3-4, Fig. 1) or " Down
Button " ( 3-2, Fig. 1 ) key to change the
High Alarm (HAL) or Lo Alarm (LAL), then
press " Measure Button " ( 3-6, Fig. 1 ) to
confirm it.
For example: When the reading 26.9
LAL 27
will hear a beep sound.
Connect the thermocouple with "
Thermocouple Socket " ( 3-11, Fig. 1 ) and
put the probe in/on the target, the
thermometer will display the temperature
automatically without pressing any button. To
see the minimum or maximum data during
the probe measurement, please hold down
the " Up Button " ( 3-4, Fig. 1 ) or " Down
Button " ( 3-2, Fig. 1).
5) The thermometer will automatically shut off if left idle
for more than 60 seconds.
, the Low icon will flash and you
℃
After measure high temp, the probe
may remain HOT for a while
6
<
℃
Advertisement
Table of Contents
