Monitoring An Automatic Timer Recording; Checking/Changing Timers - Radio Shack Optimus 64 Owner's Manual

16-634.fm Page 37 Tuesday, July 20, 1999 5:37 PM
To record a broadcast at a specific time
and date , repeatedly press
select the specific date.
Press to store your selection.
9. Repeatedly press or hold down
to select the start hour. When the correct
hour appears, press
press or to select the minute and
press .
Note: Your VCR uses a 12-hour clock. Be
sure you correctly set AM or PM.
10. Repeat Step 9 to set the end time.
11. Repeatedly press
channel and press
To record from a source connected to the
R-AUDIO-L IN 1/VIDEO IN 1
repeatedly press
LINE 2 appears, and press
12. Repeatedly press
set program category that you see when
you view the program index —
, ,
MUSIC COMEDY
(not applicable). Then press
N/A
13. Repeatedly press
tape speed ( SP , LP
.
14. Double-check all the set information.
• If the information is correct, press
• If an entry is not correct, repeatedly
press or
the incorrect entry, enter the correct
information, then press
The timer settings appear on the TV
screen. To enter another setting, repeat-
edly press or
number and repeat Steps 8 –13.
15. Press again.
PROG
TIMER RECORDING
16. Press to turn off the VCR. TIMER
POWER
appears.
or to
or
. Then repeatedly
or to select the
.
or jacks,
AV2
or until LINE or
1
.
or to select a pre-
,
DRAMA
, , or
MOVIE SPORTS
.
or to select the
, or SLP ). Then press
.
PROG
to move the cursor to
.
PROG
to select another timer
TURN VCR OFF FOR
briefly appears.
Notes:
• Be sure that TIMER appears when you
turn the VCR off. If it does not appear,
check your entries.
• If you load a cassette with its erase-protec-
tion tab removed and set the VCR's timer,
the VCR ejects the cassette and TIMER
and flash.
• If you set up the VCR to record a cable
broadcast through a cable box, be sure to
leave the cable box turned on and tuned to
the desired station before the broadcast
starts.
• You can manually turn on and operate the
VCR before the set times, but the VCR
starts an automatic timer recording only if
the power is off at the set start time.
Monitoring an Automatic Timer
Recording
1. Turn on the TV and set it to the same chan-
nel as on the back of the VCR.
3-CH-4
Note: If you are using a TV/monitor that is
connected to the VCR's
jacks, set the TV/monitor to its video
OUT
mode.
2. Press until VCR appears.
TV/VCR

Checking/Changing Timers

1. Turn on the TV and set it to the same chan-
nel as on the back of the
3-CH-4
VCR.Note: If you are using a TV/monitor
that is connected to the VCR's
jacks, set the TV/monitor to its
VIDEO OUT
video mode.
2. Turn on the VCR and repeatedly press
until VCR appears.
VCR
R-AUDIO-L/VIDEO
R-AUDIO-L/
TV/
37