Vcr Setup; Setting The Vcr's Output Channel Switch; Remote Control; Installing Batteries - Radio Shack Optimus 64 Owner's Manual

16-634.fm Page 13 Tuesday, July 20, 1999 5:37 PM

VCR SETUP

SETTING THE VCR'S OUTPUT
CHANNEL SWITCH
If you connected the VCR's
nal to a TV or another VCR, set
back of the VCR to or
3
active channel in your area.
When VCR appears on the display, the VCR
sends the signal from the video source con-
nected to its
IN FROM ANT.
(or on the front panel) terminals
VIDEO IN 1 AV2
to the TV on the channel you selected.
Note: Setting has no effect on the TV
3-CH-4
when the VCR is off or if you connected a TV
with separate audio/video input jacks to the
VCR's
R-AUDIO-L/VIDEO OUT

REMOTE CONTROL

Installing Batteries

The remote control requires two AA batteries
(not supplied). For the longest operation and
best performance, we recommend alkaline bat-
teries (such as RadioShack Cat. No. 23-557).
Cautions:
• Use only fresh batteries of the required
size and recommended type.
• Do not mix old and new batteries, different
types of batteries (standard, alkaline, or
rechargeable), or rechargeable batteries of
different capacities.
1. Press the tab on the battery compartment
cover and lift off the cover in the direction
of the arrow.
Tab
termi-
OUT TO TV
on the
3-CH-4
, whichever is not an
4
or
R-AUDIO-L IN 1/
jacks.
2. Put fresh batteries in the compartment as
indicated by the polarity symbols (+ and –)
marked inside.
3. Replace the cover.
Note: When the remote control stops working
or operates poorly, replace both batteries.
Cautions:
• Never leave dead or weak batteries in the
remote control. Batteries can leak chemi-
cals that can damage your remote control.
• Dispose of dead batteries promptly and
properly; do not bury or burn them.

Using the Remote Control

To use the remote control, aim it at the front of
the VCR and press the desired function but-
tons.
13