Radio Shack Optimus 64 Owner's Manual page 20

16-634.fm Page 20 Tuesday, July 20, 1999 5:37 PM
2. While holding down
number for your TV using the number but-
tons Or, while holding down
enter the code number for your cable box
or direct-to-home satellite receiver.
Precede a single-digit code number with a
0 — for example, 01, 02, and so on. To
enter a three-digit number, press
enter the second and third digits in the
code number.
3. Try operating your TV and cable box or
direct-to-home satellite receiver using the
VCR's remote control. First press
, then try pressing
DSS/CABLE
, s or t, and
INPUT CH CH
operation; or
POWER
cable box or direct-to-home
receiver operation.
If the device does not function, repeat Step
2 and try other codes for the manufacturer.
If it still does not function, you must use the
original remote control supplied with your
TV and cable box or direct-to-home satel-
lite receiver.
To use the remote control, press the button for
the device you want to control—
or . Then press the desired function button.
VCR
Notes:
• The codes you programmed might be
erased if you remove the batteries from the
remote control (to replace them, for exam-
ple). If this happens, re-enter the codes
after you replace the batteries.
• Some TVs, cable boxes, and direct-to-
home satellite receivers might require that
you manually turn on the power for that
device.
• Your TV, cable box, or direct-to-home sat-
ellite receiver might have functions that the
VCR's remote control will not operate.
20
, enter the code
TV
,
DSS/CABLE
, then
100
or
TV
,
POWER
for TV
VOL +/–
and s or t for
CH CH
satellite
, ,
TV DSS/CABLE
• You can use the number buttons to select a
channel number on your TV and cable box
or direct-to-home satellite receiver. How-
ever, some TVs and cable boxes or direct-
to-home satellite receivers might require
that you press
DISP/ENT
channel number.
• works to adjust the TV volume in
VOL +/–
any operation mode (VCR, TV, or DSS/
CABLE).
• When you press or
TV
press or
MENU/ACTION
CABLE/DSS MODE PLEASE PUSH VCR
appears, and TV or
KEY ON REMOTE
flash for about 5 seconds then dis-
CAbL
appear. Press to set the remote con-
VCR
trol to VCR operation mode.
after entering the
then
DSS/CABLE
,
PROG NOW TV/