Inglesina Spa Instructions Manual page 27

FIG 2/3 ASSEMBLY OF THE CHANGING TABLE LEGS
WARNING! Always make sure that the connection bars B are properly hooked on both
sides, verifying that small teeth X have completely come out.
FIG 4/5 ASSEMBLY OF THE SUPPORT SHELF
EN
FIG 6/7 HOOKING OF THE HOLDER
WARNING! Make sure that the bar E is properly hooked verifying that the plastic buttons
have completely come out.
FIG 8/9 ASSEMBLY AND OPENING OF THE CHANGING TABLE SURFACE
Always use the changing table with the standard supplied pad.
WARNING! Make sure that the changing table surface is completely hooked verifying that
the plastic buttons have come out completely.
FIG 10/11/12/13 ASSEMBLY OF THE BATH
The changing table has always to be used with the tub inserted in the proper seat.
WARNING! Always make sure that the bath L is properly in its seat.
FIG 14/15 CLOSING OF THE CHANGING TABLE SURFACE
WARNING! When the changing table is in closed position, always block it with the suitable
elastic band O.
FIG 16 USE OF THE BATH
NOTE: remember to insert the plug M always before filling the bath with water.
WARNING! The tub has to be filled in up to maximum 7 cm from the bottom. In any case,
water shall never exceed the baby belly button level. Always verify that the water level is
not too high even according to the position of the baby in the tub.
27 27