Tilt And Swivel Base - Philips 170V7 Service Manual

17" LCD Color Monitor
5.5 Location of Control icons -
5.6 Color for resin/paint -
5.7 Resins
•
RoHS required
•
WEEE required.
5.8 If paint is used
•
Rohs required
•
WEEE require
5.9 Plastic mold tooling
• Tooling to be designed to minimize cosmetic defects induced by molding process (sink, blush, weld lines,
gate marks, ejector marks, etc.).
• Painting to cover up cosmetic defects due to molding is strongly discouraged.
5.10 Plastics flammability
• All Plastics to be Flame Retardant UL 94-V0 or Better (if monitor weighs less than 18kg; UL94-V0 is OK).
• All major plastic parts (bezel, back cover ) need to be molded from same resin.
5.11 Texture/Glossing of housing
• The texture area and texture no should follow Philips make-up sheet.
• The exterior surfaces shall have a uniform texture.
• Philips must approve the mold texturing.
• Detail document for texture refer to UAN-D249.
• < = 20 gloss units

5.12 Tilt and swivel base

Tilt angle: -5 ° max (forward) and +20 ° min. (backward).
5.13 Label
• Regulatory label / Carton label should follow Philips requirement.
• Detail document refer to Philips Engineering Reference Book.
5.14 Product dimension / Weight
•
Unit dimension (incl. pedestal) : W: 380 mm, H: 387 mm, D: 200mm
•
Packed unit dimension ( WW carton) : W: 449mm, H: 182mm, D: 489mm
•
Packed unit dimension (carton) - W: 460mm, H: 189mm, D: 499mm for China, India
•
Net weight
•
Gross weight
•
5.15 Transportation
Transportation standards refer to TYE-M0002.
Per Philips Graphic sheet
Per Philips make-up sheet
:
82
: 4.7 Kg (Including I/F cable )
6.1 Kg （for WWW）
6.2 Kg ( for PRC )
170V7