B-band UST Installation Instructions And User Manual page 14

8.1 8.2 A1, A2, A2.2
8.2. For installation of the 1470 AST (steel string guitars; x-braces),
place two bridge pins in their holes, one at the low "E" string side and
one at the high "E" side. Set the bridge pins normally. This, with the
cardboard mounting guide / AST assembly will guide the AST to fit
correctly. Having the AST cardboard mounting guide / AST assembly
lying on the bottom of the guitar, remove the adhesive protective layer
from the AST. Lift the assembly up and guide the assembly so the
bridge pins insert the guide holes and carefully place it to the bridge
plate. Then stick it firmly by holding and pressing firmly with fingers
for a short while. Next carefully remove the cardboard guide. Make
sure the AST fits there tight and secure.
8.2
A1, A2, A2.2
Inside the guitar, make sure that the UST and/or AST leads do
not touch anything. We do not recommend attaching the leads to the
guitar by any means. This may cause excessive handling noise and
resonance that sounds like distortion.
8.3. For classical guitars the install the 1470 AST by hand at the
area described at 5.1.1. Remove the adhesive protective layer from
the AST. Then stick it firmly by holding and pressing with fingers
for a short while.
8.4. If necessary, you can remove the AST but be careful when doing
this. Carefully lift under the edge of the AST, with your fingernail, and
work it off slowly. Don't attempt to lift the AST off by pulling on the
transducer lead. Peel the adhesive off the wood, rather than peeling
the pickup off the adhesive. At installation this can be removed and
reattached two or three times. Note that after 24 hours the adhesive
will dry and it will be hard to remove. Removal after this time may
break the pickup.
14