Handheld digital tachometer
specialized software (27 pages)
Summary of Contents for Nidec-Shimpo FG-3000
Page 1
Presented By Dallas Ft Worth Austin Houston NicolScales.com 800.225.8181 Contact Us Nicol Scales & Measurement is an ISO Accredited Calibration Company that has provided calibration, repair and sales of all types of weighing and measurement products since 1931.
Page 2
At 110% of the rated capacity, the display will flash a warning. When mounting FG-3000 Series Digital Force Gauges, use M4 mount- ing screws with a maximum insertion depth of 7 mm into the gauge. Hand tighten mounting screws, DO NOT use tools. Do not use damaged clamp.
Page 3
3. SETUP 1.3 Menu Structure 3.1 Measurement The FG-3000 Series Force Gauge has multi-level menu interface The Measurement menu contains the Unit of measure and Mea- (Table 1-3) that enables simple navigation and programming. surement Mode sub-menus, as shown in Fig. 3-1.
3.3 Select Test Mode 4.1 Memory The FG-3000 has 3 types of Test Modes. Track: The real time measuring mode. Under this mode, press the ZERO key to tare any initial reading being displayed. Peak: In Peak mode, the maximum force will be recorded and displayed.
Page 5
5.2 Auto Power All data points can be cleared from memory under the Delete all The FG-3000 has an automatic power off function. With Auto Pow- sub-menu (Fig. 4-4). A confirm window will appear asking you to er on, if there is no operation performed within five minutes it will confirm.
5.6 Calibration Because of the sensor material performance or the influence of external factors, there may be errors of a certain level after a period of usage. It is recommended to send the force gauge to a specialized test- ing organization for calibration. Fig.
Do not disassemble the gauge by your- RS-232 Specifications: self or attempt to repair. If you cannot resolve the fault yourself, -Hardware Flow Control: None please contact Nidec-Shimpo. -Data word length: 8 bits -Stop bit: 1bit -Parity: None...