English - ION VERTICAL VINYL Quick Start Manual

QUICKSTART GUIDE (ENGLISH)
Make sure that the items listed below are included in the box: VERTICAL VINYL, 4 AA batteries, 45 RPM
o
adapter, Quickstart Guide, Safety Instructions & Warranty Information Booklet
READ SAFETY INSTRUCTION BOOKLET BEFORE USING THE PRODUCT
o
Go to http://www.ionaudio.com for product registration.
o
Mounting VERTICAL VINYL on a wall: VERTICAL VINYL has two holes on its back panel, which you can use to
hang it from your wall. Do this in the same way you would hang a heavy picture. We recommend screwing your
mounting screws into the wall studs, which you can locate using a standard stud finder.
Playing a record:
1. Loosen and remove the plastic cap from the turntable's platter by turning it clockwise.
2. Place your record on the turntable.
3. Place the plastic cap back on the turntable's platter by screwing it counterclockwise, tightening it to secure the
record in place.
4. Power on the unit by turning the volume knob clockwise so it clicks. (The LED above it will light when the power
is on.)
5. Select the proper playback speed with the 33/45 RPM switch.
6. Remove the arm clip holding the tonearm in place, and place the tonearm on the record. Adjust the volume as
desired.
FEATURES
1. BATTERY COMPARTMENT
Remove the cover and place 4 AA
batteries into this compartment. Be
sure the positive and negative poles
of the batteries are facing the proper
direction.
2. POWER INPUT – If you prefer to
power VERTICAL VINYL via wall
power instead of batteries, you can
connect a 6V DC, 500 mA power
adapter (not included) to this input,
then connect the adapter to a wall
outlet.
3. SPEAKER – The record's audio will
be played through
speaker.
4. VOLUME/POWER KNOB – To power on VERTICAL VINYL, turn this knob clockwise until it clicks. When
powered on, use this knob to adjust the volume. To turn off VERTICAL VINYL, turn this knob counterclockwise
until it clicks.
5. PLATTER – Place your record here, securing it to the
platter with the plastic cap. (Loosen the cap by turning it
clockwise; turn it counterclockwise to tighten it.)
6. ARM CLIP – This specially designed arm clip secures the
tone arm while at rest or when not in use.
7. TONEARM – VERTICAL VINYL comes with a ready to use
pre-balanced TONEARM and cartridge. The TONEARM can
be raised and lowered by hand. Please note that the
TONEARM needs to be moved away from resting position (on the ARM CLIP) for the turntable motor to
activate. When the TONEARM is placed back in its resting position, the turntable motor will deactivate.
Note: You can replace the stylus with the ION iCT05RS, available at www.ionaudio.com/ict05rs.
8. 33 / 45 RPM SWITCH – This switch controls the RPM of the turntable platter
9. 45 RPM ADAPTER HOLDER – Holds the included 45 RPM adapter. When not using the adapter, please place
it in this holder.
10. Phones - Connect 1/8" stereo headphones here (not included). The speaker output stops playing audio once
headphones are connected.
–
this built-in
9
5
IMPORTANT: Make sure that the slipmat is
always placed on top of the platter while using
the turntable.
cause damage to your media as well as damage
to the turntable.
Remove the plastic cartridge cover (needle
cover) before operating the turntable.
3
8
4
3
6
7
10
Failure to use the slipmat may
1
2