Dismantling Instructions - Hotpoint WDL756PUK Service Information

Indesit Company

DISMANTLING INSTRUCTIONS

Safety Notes:
Ensure that the appliance is disconnected form the Electricity Supply before
commencing any work. Beware of sharp edges on metal or plastic parts - wear safety
gloves. Refer to Safety Notes at the beginning of this publication.!
IMPORTANT NOTE
Risk of Electric Shock
The metal heatsink fitted on the Power Module
may hold an electrical charge for a short period
after switching off the machine.
Allow 5 minutes after disconnecting the
machine from the electrical supply before
commencing ANY work.
A Top Cover
1. Remove the 2 screws securing the top panel.
2. Lift clear.
B Back Panel
1. Remove 6 screws securing the panel.
2. Lift the panel clear.
C Control Panel
1. Remove the top cover (A).
2 Open the dispenser drawer fully. Gently lift slightly and pull to remove the drawer.
Remove the 3 screws securing the control panel to the dispenser housing.
3. Release 2 screws, 1 each end on the top corner of the control panel.
4. Release 2 clips holding the control panel to the cabinet, gently ease the control panel upwards to
disengage the lugs from the front panel.
5. Disconnect the wiring and lift clear. NOTE: When refitting, ensure the control panel is screwed and
secured into the dispenser body. This is easier to check with the dispenser drawer removed.
D Control Card
1. Remove the top cover (A).
2. Release the wiring block from the side of the card.
3. Remove the crosshead screws fixing the PCB to the control panel.
NOTE: Be careful not to lose the anti-condensation sheet and note positioning of the sheet onto the
card when refitting
E Top Concrete Weight
1. Remove the top cover (A).
2. Remove 3 bolts (10 mm) securing the weight to the outer drum.
Service Manual UK
10 of 33
English