End of the guide bar may be placed at the
height of about 50 cm (20 in.).
Rear handle should be gripped lightly with the
right hand.
CS-4510
AUTOMATIC CHAIN BRAKE
Kickback produced from the tip of the guide bar will
trip the automatic chain brake. To make sure that
the automatic chain brake operates properly, follow
these steps:
1. Stop the engine.
2. Hold the saw with the guide bar approximately
50 cm
(20 in.)
3. Release the front handle and drop the end of the
4. The impact should lock the chain brake.
24
50 cm (20 in.) above a wooden surface. Right
hand should hold the rear handle, and left hand
should hold the front handle.
guide bar against the wooden surface.
IMPORTANT
When checking the operation of the automatic
chain brake, use a soft surface substance like
wood to provide the impact so the chain is not
damaged.