Toyota Avalon Hybrid 2018 Owner's Manual page 213

Changing settings of the pre-collision system
■
Disabling the pre-collision system
Press the PCS switch for 3 sec-
onds or more.
The PCS warning light will turn
on and a message will be dis-
played on the multi-information
display.
To enable the system, press the
PCS switch again.
The system is enabled each
time the power switch is turned
to ON mode.
■
Changing the pre-collision warning timing
Press the PCS switch to display
the current warning timing on
the multi-information display.
Each time the PCS switch is
pressed with the warning timing
displayed, the warning timing
will change as follows.
The operation timing setting is
retained when the power switch
is turned off.
Far
1
The warning will begin to oper-
ate earlier than with the default
timing.
Middle
2
This is the default setting.
Near
3
The warning will begin to operate later than with the default timing.
4-5. Using the driving support systems
213
4