Antunes DFW-150 Owner's Manual
Hide thumbs Also See for DFW-150:

Advertisement

DFW-150/250
Deluxe Food Warmer
owner's manual
Manufacturing Number:
9100162, 9100165 &
9100169
www.antunes.com
P/N 1011195 Rev. E 08/17

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the DFW-150 and is the answer not in the manual?

Questions and answers

Summary of Contents for Antunes DFW-150

  • Page 1 DFW-150/250 Deluxe Food Warmer owner’s manual Manufacturing Number: 9100162, 9100165 & 9100169 www.antunes.com P/N 1011195 Rev. E 08/17...
  • Page 2: Table Of Contents

    Serial Number Warranty in this manual. IMPORTANT If the unit arrives damaged, contact the car- A.J. Antunes & Co. reserves the right rier immediately and file a damage claim with Manufacturing Number to change specifications and product them. Save all packing materials when filing a design without notice.
  • Page 3: Important Safety Information

    IMPORTANT SAFETY WARNINGS INFORMATION • The following tips are recommended Be advised of the following warnings when operating and performing maintenance on for maintenance of your stainless steel Use the following guidelines for safe opera- equipment: this unit. tion of the unit. •...
  • Page 4: Specifications

    SPECIFICATIONS SHIPPING WEIGHT DFW-150 Models 40 lbs (18.2 kg) DFW-250 Models 40 lbs (18.2 kg) CAPACITIES DFW Series 2-7/8” (73 mm) deep half-size steam table pan Model & Width Depth Height Mfg. No. DFW-250 16 1/2" 17 1/8" 9" 9100162...
  • Page 5: Installation

    Pan Diffuser • Owner’s Manual Tank • Authorized Service Agency Directory Cover NOTE: If any parts are missing or dam- aged, contact Antunes Technical Service IMMEDIATELY at 1-877-392-7854 or 1-630-784-1000. Operating Controls 3. Remove all packing materials and Spray Tube protective coverings from the unit.
  • Page 6: Plumbing

    DFW-150 MODELS 20–25 psi (1.4–1.7 kg/cm 2 or 138–172 kPa). 3. Turn the water valve on. The DFW-150 models have a self-contained 4. Over a bucket, press and hold water tank. To fill the tank: the white plastic tip on the Quick Disconnect Insert (Figure 2) until a 1.
  • Page 7: Operating Instructions

    PROGRAMMING 8. Press and release the Program button again and press ▲ or ▼ to change the Ready Light CYC (Total Cycle Time) refers to the total SHO in minutes. programmed steam time set for the product. Message NOTE: Refer to Table 1 for the recommend- Display ed settings for your unit.
  • Page 8: Hi-Limit Reset Button

    DFW-250 units or to the water red reset button located on the rear of the precautions and warnings on product label. pump used in the DFW-150 units. unit (Figure 4). NOTE: This LED is only lit for approxi-...
  • Page 9: Monthly Maintenance

    Pan Diffuser Tank Cover Spray Tube Assembly Figure 5. Components (DFW-150 Shown) MONTHLY MAINTENANCE 6. Use a scraper or spatula to remove the Seasoning mixture consists of 3/4 ounces (25 excessive calcium/mineral buildup from ml/25 cc) baking soda, 3/4 ounces (25 ml/25 CLEAN SPRAY TUBE AND STEAM the generator surface (Figure 6).
  • Page 10 MONTHLY MAINTENANCE Tank Cover WATER TANK FILTER (DFW-150 ONLY) Water Tank Filter The water tank filter is used to prevent par- ticles or food products from entering and Filter Stem damaging the water pump. Inspect and clean this filter monthly or more regularly using the following procedure.
  • Page 11: Troubleshooting

    TROUBLESHOOTING WARNING To avoid possible personal injury and/or damage to the unit, inspection, test, and repair of electrical equipment should be performed by qualified service personnel. The unit should be unplugged when servicing, except when electrical tests are required. Use extreme care during electrical circuit tests.
  • Page 12 TROUBLESHOOTING (continued) Problem Possible Cause Corrective Action Unit heats but there is little or no Filter Strainer and/or Spray Tube is restricted. Check and clean the Filter Strainer and Spray Tube steam as described in the Maintenance section of this produced manual.
  • Page 13: Replacement Parts

    REPLACEMENT PARTS Dual Water Pressure Regulator Kit - Part No. 7000235 Item Part No. Description Qty. To Steamer 7000139 Elbow, Quick To Steamer Disconnect - 1/4” 2030126 Tubing 1/4” I.D. PVC BRD. 24” Long 2030125 Tubing 1/4” I.D. PVC BRD. 12” Long 2040150 Elbow, Male - Nylon 2 1/4”...
  • Page 14 REPLACEMENT PARTS (continued) P/N 1011195 Rev. E 08/17...
  • Page 15 REPLACEMENT PARTS (continued) Inset A See Inset B (Mfg. # 9100162 only) (Mfg. # 9100162 only) See Inset A Inset B – Direct Water Hook-Up Inset B – Self-Contained Water Tank P/N 1011195 Rev. E 08/17...
  • Page 16 REPLACEMENT PARTS (continued) Item Part No. Description Qty. Item Part No. Description Qty. Item Part No. Description Qty. 0012856 Top Cover Assy. 26 0502719 Hinge Base 49 7000156 Audio Alarm Kit 0200315 Gasket, Cross Over 27 0600125 Spring 50 0503333 Bracket, Temperature 1 Access Cover 28 0020952 Hinge Beam Sensor...
  • Page 17: Wiring Diagram

    WIRING DIAGRAM For DFW-150 Mfg. No. 9100169 P/N 1011195 Rev. E 08/17...
  • Page 18 MOMENTARY THERMOCOUPLE SWITCH TERMINAL BLOCK HEATER HI-LIMIT S.S. RELAY THERMOSTAT CONTROL (PUMP ONLY) BOARD SOLENOID PUMP DIODE ASSY. (PUMP ONLY) POWER SWITCH 120V 230V TRANSFORMER For DFW-150 Mfg. No. 9100165 and DFW-250 Mfg. No. 9100162 P/N 1011195 Rev. E 08/17...
  • Page 19: Notes

    NOTES P/N 1011195 Rev. E 08/17...
  • Page 20: Limited Warranty

    2. Antunes reserves the right to make changes in design or add any improvements on any product. The right is always reserved to modify equipment because of factors beyond our control and government regulations. Changes to update equipment do not constitute a warranty charge.

This manual is also suitable for:

Dfw-250

Table of Contents