Safety Information; Installation Information - Utilitech 6211W-PIR26B User Manual

SAFETY INFORMATION

Please read and understand this entire manual before attempting to assemble, operate or install
the product.
WARNING
●
This light fixture is designed to fit standard junction boxes as defined by the National Electrical
Code.
●
To prevent electric shock, ensure that the power is disconnected before installation.
●
Consult a qualified electrician if you are not certain about the installation process. Always install
wiring connections in accordance with local code, ordinances and the National Electric Code.
●
Changes or modifications to this unit not expressly approved by the party responsible for
compliance could void the user's authority to operate the equipment.
●
After turning on the switch, temperature of bulb rises gradually. Do not touch bulb with bare
hands until bulbs have completely cooled. When changing the bulb, first turn off the power and
allow the bulb to completely cool.
● The bulb must not exceed the specified wattage.
● To control the floodlight manually, the control must be wired through a switch.
NOTICE: This equipment has been tested and found to comply with the limits for a Class B digital
device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable
protection against harmful interference in a residential installation. This equipment generates, uses
and can radiate radio frequency energy and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio communications. However, there is no
guarantee that interference will not occur in a particular installation. If this equipment does cause
harmful interference to radio or television reception, which can be determined by turning the
equipment off and on, the user is encouraged to try to correct the interference by one or more of the
following measures:
-Reorient or relocate the receiving antenna.
-Increase the separation between the equipment and receiver.
-Connect the equipment into an outlet on a circuit different from that to which the receiver in
connected.
-Consult the dealer or an experienced radio/TV technician for help.

INSTALLATION INFORMATION

● CAUTION: To avoid water damage and the risk of electrical shock, the motion sensor controls
must be facing the ground when the installation is complete.
● NOTE: Do not connect this light fixture to a dimmer switch or timer.
● NOTE: Do not install motors, transformers, or fluorescent light fixtures on the same circuit with
the fixture.
● NOTE: This fixture is designed for outdoor installation and should be mounted to a wall or eaves.
The detector is less sensitive to motion directly toward it and more sensitive to crossways motion.
3