Memorex Mi4290P User Manual page 15

TO SYNC THE TIME
1
ALARM1
With the power on, connect an iPod as shown
on page 9. Press the SYNC button; the
display time will blink and "SYNC" will blink
thrice. The time and day of the week will then
be synced.
NOTE: The Sync function can sync the time
with the iPod once only, unless the iPod is
unplugged and plugged in again. The SYNC
button will not set the alarm. The iPod mini,
iPod photo and iPod 4th generation do not
support the SYNC function.
If you have been traveling, please make sure
to reset your iPhone or iPod device so that
the system clock on your device is updated to
your current time zone. We recommend that
you turn your iPhone or iPod device "OFF"
and "ON". Also make sure to turn the unit
"OFF" and "ON" and then, dock your iPhone
or iPod device to SYNC.
TO SET OR RESET THE ALARM TIME
1
1
ALARM1
Press and hold either the ALARM
1 button 1 (to set Alarm 1) or
ALARM 2 button 2 (to set Alarm
2); the Alarm hour will blink in the
display.
OPERATION (CONTINUED)
ALARM2
2
ALARM2
CONTINUED ON THE NEXT PAGE
DST (DAYLIGHT SAVINGS TIME)
1
For your convenience, there is a
DST (Daylight Savings Time)
switch located on the rear of the
unit. Slide the switch to +1 to add
an hour to the actual time or slide
the switch to -1 to subtract an
hour from the actual time.
2
3
Within ten seconds, press the Volume/Time
Up 1 and/or Down 2 button on the main unit
to set the alarm hour. If the 24 hour switch is
set to Off (12 hour mode), be sure to observe
the AM or PM indicators to make sure you
have set the hour correctly. Press the ALARM
1 button 3 (when setting Alarm 1) or ALARM
2 button 4 (when setting Alarm 2); the
minutes will blink.
15
2
4
ALARM1 ALARM2